Here's the correct Moog tie rod #ES3198RL. It fits the steering knuckle properly without redrilling. You just have to cut the long threaded shaft off before welding it onto your hydraulic ram. It is high quality steel and welds nicely with a MIG.
@JeremyWiley1004 ай бұрын
I have two that have broke that bolt. I am over paying 630 each time and wondered if it worked. Any issue with use since installing?
@janisvinters87973 жыл бұрын
Maybe you can put that tie rod end number or know from what vehicle it was. I trying to find right one to weld to it.
@Ragesh.Krishna4 жыл бұрын
Hai, is it possible to pull out the old bush and install a new bush ?
@fixitwise71943 жыл бұрын
Did the heat affect the hydraulic cylinder at all?
@timothygraham66016 жыл бұрын
Great job, is it still holding?
@5whitens6 жыл бұрын
Do u have any idea what the replacement tie rod came off? I have the same issue.
@ToolManThibert6 жыл бұрын
I think it was from a chevy car it was just lying around the shop for years so exact model unknown
@janisvinters87973 жыл бұрын
Very good sollution how to rebuild John Deere Hydraulic Cylinder (part.no. AM116872) and not to bye new one for 500$ if old one is still working fine without leaks etc.