JEEP CJ5 FRONT WHEEL BEARINGS REPLACE

[@rharris7635]

Great how-to video. Thanks for the easy to follow step by step and comments. I will tackle my '78 CJ7 soon.

[@joetaravella848]

Glad it was helpful!

[@Hawksnest1976]

Thanks so much for your information brother great video

[@joetaravella848]

No problem 👍glad I could help

[@COPPER71]

I'm getting ready to do this myself on my 74cj5

[@joetaravella848]

Not that hard Mostly a lot of cleaning

[@makingcookingfixing]

at 21:00 in your video, that large flat washer with the tab, that tab slides on the axle groove and goes under the first nut. The second nut, you asked how nothing is preventing it from opening again, well, you supposed to bend that washer in between the nuts forward over the last nut, you do that with a flat screwdriver, then the last nut will never turn for sure!

[@joetaravella848]

That’s good to know Both side where done different So I was kinda winging it Thanks

[@t.sutt.7768]

I like brass punches.

[@joetaravella848]

Me too I was at my farm using what was on hand Thanks for watching!

[@daveelliott8116]

Nice farm shop

[@joetaravella848]

Thanks

[@Deuceblank]

Our 78 getting new bearings soon. Cant believe there are now C clips

[@joetaravella848]

Yea there system works though

[@patirving1461]

The larger of the spined washers gets tapped over the inside, not so the inside, not can no longer turn

[@patirving1461]

That was supposed to say the inside nut, so the inside nut can no longer turn

[@joetaravella848]

Yea as I was putting it together I seen the method of their madness Check out my new video I’m transplanting a Jeep on a Toyota Tundra Frame It’s turning out to be a real butt kicker! Thanks for watching! And I appreciate the feedback

[@kenns9]

hello, yes im a year late. at 18:21 why does it appear that the short brake shoe is rear of the hub and not forward of the hub where it belongs.

[@joetaravella848]

That’s a good question We replaced them Probably put them on the way the last guy had them Everything on this Jeep way jerry rigged Thanks for watching and the info

[@joetaravella848]

Man I’ll be honest with you I would just keep going deeper till I see the problem With that much play it should be obvious once you hit it Looks like something is bad in that pivot point Probably dirt and grit has worn something out in there Sorry I couldn’t help more But let me know what you found Thanks for watching my video