Jeep TJ Wrangler Crankshaft Position Sensor Replacement

I have the same exact jeep with the same exact code; this was really helpful

[@slurpie_official690]

So if my Manuel takes 2 bolts to hold and I ordered the one like yours, would it be fine to put in or should I order the right one

[@TabooCustoms]

You will want to buy the correct one for the manual, the sensor spacing and structure is different.

[@bobbyridlen7424]

Code P0320 replaced CKP still no start and now some fuses aren't getting power.

[@TabooCustoms]

@@bobbyridlen7424 fuses at PDC under hood or the fuse block behind glove box?

[@jorgecastellanos8621]

Nice video, have question my jeep when pass 10 or 15 minutes fail and turn off wait about one hour and start perfect, change gas pump same issue i think is crank sensor?

[@TabooCustoms]

No codes? I haven't known the crank sensor to do that. I would put a fuel pressure gauge on it and see what it does when it's dieing. Maybe Idle Air Control valve is what I would look at next

[@abdullahal-mahbashi9567]

Guys I have jeep wrangler model 2010 diesel. I have changed new fule pump and 4 new injectors. After 6 month of driving it now suddenly there is no power while accelerating. What should I change to fix the problem? The engine light is on as well. Any one experience the same thing. I’m in Australia and mechanics are sucks here

[@TabooCustoms]

Unfortunately in the US we didnt get diesel wranglers so we personally havent worked on any. My guess is that a sensor or something in your injection system is bad again. Can you get a scanner to see what codes are being thrown causing the check engine light? That would be the first step towards potential fixes.

[@jamesbrewer5925]

On the 2004 a/t its on passenger side just above starter

[@paultrendell1815]

Thank you very much

[@joshpitts25]

Just replaced mine and not fixed I guess part is bad??

[@TabooCustoms]

What is the jeep doing, has a code, running poorly, won't run, dies? Could be various causes depending on symptom.

[@joshpitts25]

Only one code for crank sensor. Won't start just cranks over. Was running great then threw code and now no start

[@TabooCustoms]

@@joshpitts25 There is a video to test the crank position sensor with a multimeter. If the crank sensor tests good then your down to checking wire continuity. I have in the past had a couple of TJs with broken wires in the harness. kzbin.info/www/bejne/fZ6kXneBh8h0mck

[@rayl9335]

Does engine have motor mount lift? May be sensor clearance was tight.