This is a service guide on how to maintain Jefa Marine rudder bearings. This should be done every third year. The video is made with a Hanse 325. The principle is the same for all Jefa Marine products.
Пікірлер: 15
@jacopocolombo41092 жыл бұрын
Contrary to Jefa's own recommendation, this rudder post seems to be electrically bonded (green-yellow wire).
@jefamarineas17342 жыл бұрын
Hi Jacopo. You are correct. But as we are not the owner of the boat we can't just remove the wire without permission. We did recommend that the wire should be removed, or at least removed from the tiller lever connected on the stock to the owner. You can read all about our recommendation and how to prevent electrolysis here: jefa.dk/electrolysis/ Br Thor
@alby50083 жыл бұрын
Did you clean the bearing with normal water + neutral soap? Thx for the help
@jefamarineas17343 жыл бұрын
Hi Alby. Normal water from the tap with dish soap.
@tonyheron32282 жыл бұрын
Hi we have an issue with loose /cracked outer cage which bearing sits in what are your thoughts on this .is it an integral part of main aluminium tube regardsTony
@jefamarineas17342 жыл бұрын
Hi Tony. Please send us some pictures of the bearing and for what boat to info@jefa.dk Best regards Thor
@StudtMarineServices11 ай бұрын
Can this be done on moored vessels? Or will the boat sink?
@jefamarineas173410 ай бұрын
Hi. Do you mean taking the rudder out? That depends if there is a rudder tube going over the waterline. But I would not recommend doing the service on the boat while it is in the water. Best regards Thor
@iztokm20022 күн бұрын
P240 grid paper to sand the rudder post. Is that not to rough for bearing seat?
@jefamarineas17345 сағат бұрын
Hello. In normal situations yes, but this rudder stock had a lot of dirt so it was first sanded with a 240 and than a 400 grit. Our normal recommendations is to use sandpaper grit 400+ and just a light pass over the rudder stock. Best regards Thor
@vechnyak4 жыл бұрын
What type of lubricant is it being used?
@jefamarineas17344 жыл бұрын
Hi! Synthetic grease (we use Castrol Synplex 2, but any winch grease will do the job).
@TheCruisingKiwis Жыл бұрын
@@jefamarineas1734 assume its not appropriate/ necessary to add grease to the inside of the bearing (in contact with the stainless shaft)?