Jeti - Assist episode 2

[@McDaniels777]

Good morning Mister Curzon, I would like to express my deepest appreciation for all the videos you do on Jeti, I just converted over and at first it seems a steep learning curve. Your methodical way and your voice are very helpful to get me to the next level. I hope you get some incentive from JETI for all the work you do for them. Thank you so much. 👍😎

[@RTD1947]

Harry, thank you so much for all your videos!!! I have relied in the Esprit videos, they are ok but yours are much better!! I have a DC24, CB400 and I fly scale CARF.

[@mellbenham6809]

Thank you for the video I'd tried doing this by reading the manual and it made no sense so came on here and had it sorted in a heartbeat so thanks for such a useful tutorial.

[@cotswoldpilot]

Thanks Mell

[@burrefpv9273]

Thanks so much for the video 🙂 It helps us the fellow jeti users allot!!!

[@michaeldamico5152]

I have a reason to change the "Receiver Placement" orientation because of the accessibility of the receiver in the airplane. If I have already set up all the rest of the Configuration Settings, can I go back now and just change the orientation setting without causing any problems?

[@michaeldamico5152]

Hello Harry, I'm replacing a Spectrum Receiver in a 3-D model where the Receiver was mounted setting on its back (not it's bottom but the short dimension) vertically with the connectors facing up. The surface of the receiver that is usually called the "Bottom" was facing forward (toward the Engine). I built a "span-wise" compartment for the Spectrum Receiver that allowed for me to put 1/4" Foam in against the front and back of the vertical surfaces of the receiver to protect it from vibration. When I look at the choices Jeti gives in the options for the REX7 Receiver, it doesn't look like the receiver can be mounted with its top or bottom surfaces facing the Engine. Please confirm that my observation is correct, and that It will be necessary for me to dismantle the Vertical Spanwise Receiver Compartment I made for the Spectrum Receiver and create a flat surface that allows the Receiver to be mounted in any other orientation than having its top or bottom side facing forward (because those orientations are not available as a Jeti option).

[@cotswoldpilot]

I believe that you are correct.