Jeti - Central Box CB 310 / 320

[@armandoabreu6593]

Excellent work. Thanks for posting this video.

[@RTD1947]

EXCELLENT VIDEO….Highly recommend watching as a refresher or First time.

[@porsche1971]

Your knowledge on this radio is amazing!! I am so impressed. I do not believe there is anyone else on this planet that knows more about this radio than you.

[@richbran10]

Harry, nice work, in the mean time (as of mid feb 2022) the (310) data is included in the normal update of the unit.. But one thing I thought confusing, partly because following the video, one tends to act very visually. As the RSATs feature about the same layout as the RCSwitch, lacking the antennas of course, you are compelled to use the same positions for connecting the power and bind plug. Curiously, it still binds. But then, as You connect it with the 310 with the normal positions, eg the "lower part" of the RCSw, after connection, the 310 shuts down. Or when starting it, it shuts down after one sec. In the 310 manual, if You study it correctly, You see that the wiring of the RCSW is on the "opposite" side, compared to the receivers. Took quite some time before tackling it..... I can send a picture of the three units side-by-side where the difference stands out, but I need an email address for that. Richard

[@armandoabreu6593]

Hi Harry, is it possible to have one channel coming from the radio and be routed to three output pins on the central box. For like a three servo wing? Thanks.

[@cotswoldpilot]

Yes, in any rx or cb, in its channel assignment menu. But why? You lose the ability to adjust each servo independently.

[@porsche1971]

hello Harry, I had the same issue, and once I did as you stated, i was able to get the 320 bin into my DC 24 and then when I went to device explorer, I was able to open CB 320 and do the programming and the output period at 10 and then failsafe enabled. Then, I programmed my Cortex pro. Once the Cortex Pro was installed and up and working, when I go into device explorer, I can see R1, under R1 I see CORTEX PRO, and then R2, but I no longer can see CB 320, which should be also under R1. ANy thoughts?

[@cotswoldpilot]

Maybe connected wires from cortex to cb wrong way around

[@porsche1971]

@@cotswoldpilot Harry, you did it again!! it is all fixed now. WOW!! You are the GOAT!!

[@cowboy01010]

Hi Harry I have the central box 400 but I don't see a tutorial on it so I was watching your video on the 320, while in the Device Explorer I found the 400 it says its disconnected, I clicked on the arrows in a circular pattern and it now only shows two sets of numbers and RC switch on the screen, and wont go back to the original screen, by the way I'm using the DS-24, Please help and do you have a video on the 400?

[@cotswoldpilot]

You have to switch on receivers and CB for Device Explorer to see them. No video about the 400