Рет қаралды 3,791
I made this jewelry box from walnut and maple.
Affiliate link to the xTool P2 55w CO2 laser.
Purchasing through this link provides me with a small commission on the sale. Using this link is not required but is appreciated.
- US: www.xtool.com/products/xtool-...
- EU: fr.xtool.com/products/xtool-p...
I had a little more difficulty using the xTool P2 compared to the hammerhead shark sculpture (see previous video). I did quite a few test cuts with walnut scraps and the result was great! But, when I started with the one intended for the box (from a different tree), none of the cuts was going through. I had to flip the boards and do my best to line up the cuts again. It was very tedious, but it worked.
I suppose that not all woods, even those of the same species, are equal in terms of their ability to be laser cut. The maple I used was perfect, very clean cuts but who knows what it would be like with a different tree.
So I learned here that I had to do test cuts on the wood for the project and on the entire width of the board (the cuts were very uneven across the grain).
All the same, the crafting possibilities of this machine are awesome. I have found it so useful to create clamping jigs for an even pressure for the leaves glue up.
I hope you enjoy the video.
Chapters
------------------------
0:00 - Intro
0:06 - Sketching ideas
0:30 - Computer stuff
1:03 - Wood prepping
02:43 - Laser !!!
03:32 - Leaves glue up
04:42 - Sharpening tools
05:16 - Carving the leaves
06:02 - Box and drawers
09:05 - Oddly satisfying
09:22 - Box and drawers again
11:04 - Brass handles
11:54 - Leaves and drawers
12:43 - Logo engraving
13:10 - Oil finish
13:37 - Final reveal
Credits
------------------------
Music : Artist: Bad Snacks Title: Take It Easy