Jimny JB74 Mud Flaps / Guard Installation

[@articn0va]

Thank you so much for showing this. I have the instructions sheet but it only shows images and no words and so I was so confused as to where the metal tab went for the front flaps. Thanks again

[@jasontozer8079]

Thanks very much for posting this excellent guide. I seriously doubt I'd have been able to figure out how to fit my set with you. Muchos Appreciado!

[@hugoboss9507]

thanks man, you safed my day! No way I would have figured that out by myself.

[@Mowch]

Perfect! Thank you I have mine installed!

[@rasheedb4762]

Thank you from the Virgin Islands

[@leopj4830]

Thanks to you i manage to install that puzzle.

[@stevenglossop4274]

Great video ,far easy than using the supplied template thanks 👍👍👍👍

[@irwinzapata3390]

thank you my friend, greetings from Mexico

[@CañonAlonso]

Thank you very much Ian. Very useful video.

[@konstantinosdimos8683]

Very useful video! There where no installation instruction with my Jimny Mud flaps.

[@stevenglossop4274]

Excellent video thanks ,only thing I would add is just remove road wheel far easier and takes minutes .👍👍👍

[@steelcucumber5708]

Thanks for the tutorial from Australia!

[@eliasmontoya8406]

Muy buena guia, muchas gracias. saludos desde Meico.

[@ShatOutaHell]

The music Is very necessary Ty

[@josepelomundo]

Thank you very much

[@ivantejadanavajas2369]

Thanks for posting this! Had no issues with the rear one, but got stuck on the front one. With the firs screw, what did you "hook" the flattened metal bit onto? It just spins when trying to screw. Thanks!

[@iansantos7808]

there is no bolt for it to be tightened. Seems like you might have over torque the screw causing a lose thread, not sure if upsizing your screw will work.

[@chrishurley5711]

You seem to slide the cli underneath the existing trim hole, isn’t the cli supposed to slide over the trim aligning with the hole

[@ivantejadanavajas2369]

Thanks for the replies! I ended up buying a plastic plug, similar to the ones that come with other mud flap kits. Did the job nicely and a bit easier I think. This is the part I used: CHAMPION FASTENERS PUSH RIVETS (18MM HEAD, 22MM LENGTH, TO SUIT 6.5MM HOLE) - PACK OF 2 - TF217

[@Joel-kj1ew]

What are the size of drills did you use? Thanks

[@iansantos7808]

5mm

[@marcoacristo]

thanks