Johnson 90 hp v4 neutral start safety switch - a close-up look how it works

[@ComputerGuyAndy]

You could simply connect the two wires together, being very careful not to leave the drive shaft in gear, while staring, until your new part arrives.

[@njfishing1]

Thanks for your tips!

[@MrRandallleeeubank]

thanks for the help

[@bercy1921]

If that switch goes out will it cause the trim not to work

[@GoSDREO]

I'm experiencing the same issue w/my outboard but my engine trim controls operate normally.

[@coreyduvall3026]

Yes

[@rparis103]

Thank u sir

[@hoffinshnizle3670]

thanks you sound bummed haha but very helpful thanks

[@jonathans444]

just use a plastic welder lol

[@njfishing1]

Thanks for the tips. Didn't know about plastic welder until googled it.

[@rayray9777]

Order new part plastic weld is a temp fix. You done fucked up lol