banshee rebuild part 2

Banshee rebuild part 2

[@AlejandroCornejo]

hello very good job where to get the tires

[@GrandLostCityBoy]

hey man you never showed how you torqued down the clutch bolt

[@DALLASFERNAND]

nice video ,,thanks

[@codywallace6656]

On the stroker crank I notice on your 1st rebuild video there wasn't a moon clip on the crank bearing. There was just an o ring. Is this normal with the aftermarket cranks?

[@joshgeordieRR]

codywallace6656 yes, but it does depend on the brand of the crankshaft

[@GrandLostCityBoy]

how can you get it off, I have a issue getting mine off

[@randall6749]

awesome...

[@ccounts2716]

Hello. I just replaced my clutch in my 05 banshee and did everything as you did and by them manual. Now when I put it in gear for some reason it barely moves. I tried readjusting the clutch and it still is the same. What can I do? Thanks

[@joshgeordieRR]

I think you have the pressure plate on wrong, it's probably sitting on top of the inner basket. There are 3 arrows on the pressure plate they need to line up with the dots on the face of the inner basket

[@codywallace6656]

See I got the 4mil stroker crank shaft and it just came with the o ring like your? So this is normal then? It is the way its supposed to be?

[@joshgeordieRR]

Yes Just make sure that the crank is all the way over to the stator side of the cases

[@frank8907]

great video, i must be doing something wrong or i missed something because my clutch isnt working it does not engage when i use the clutch lever it has 0 resistance any suggestions?? thanks

[@joshgeordieRR]

Did you forget the ball bearing?

[@frank8907]

the little one single ball that goes in after the rod no

[@Vmaxkw]

Forgot the convex/concave washer on the primary and water pump gears.

[@joshgeordieRR]

No I didn't if you look close at 3:43 you can see it.

[@ccounts2716]

I only have one dot on my inner basket and 3 arrows on my pressure plate

[@joshgeordieRR]

Make the arrow line up with the dot,the inner basket should fit into the back of the pressure plate

[@doretheacoleman3913]

ii

[@ccounts2716]

Ok I will remove it and reinstall first thing in the morning. And I will get back with you when I do. Thanks again