Kapanadze Output Transformer -Part 2

• Low Power Mini-Kacher ...
#Tesla #Kapanadze #RadiantEnergy #Longitudinal #Transverse #Modulation #StandingWave

[@gfusioncore9471]

Enjoying your experimentations JB, keep it going. This is going in the right direction getting to know stuff ;)

[@JB-20]

Thanks Bro.

[@endlessanalog]

Can you show or explain what you are using to charge the capacitor across the spark gap AND show the primary winding inside the tube? Thanks!

[@full954]

Большую резонансную мочность можно снять только зарядив конденсатор и разрядив на нагрузку.

[@user-wu2mz8ii8v]

،👍🏼👍🏼👍🏼

[@dkdyker]

JB, so your catcher is a large alluminium plate direct to the caps spark and primary??? What setup are you using?? What if you could send the voltage to the input to loop itself?

[@JB-20]

A usual, since early 90's and even during in grade school. Trying to make a loop. But, what you found is also the same with mine. The word tuning and fast cap charging is what we mention at the end.

[@endlessanalog]

I noticed that the spark gap discharge rate slowed when the ground wire was attached to the base of the lightbulb. This would indicate that the bulbs are being illuminated by using the air as dielectric for capacitive coupling between Tesla coil and ground. In other words, the light bulbs can easily glow with the ground wire alone by conducting between the bottom lead of the Tesla coil and ground and the discharging capacitor across the spark gap account for the pulsating phenomenon seen in the lights. What would be interesting is if you were to add a matching / partnered output coil wound in the opposite direction and with a resonant capacitor across that coil. If you find the right spark gap frequency and achieve resonance with the partnered coil it will create an additional field that will be present in the main output coil

[@JB-20]

Yeah, you're right. It can be easily illuminated by only using the base terminal(common ground) of the Cacher and the Earth. Gap explained @2:17, you're exactly right. We could energized everything within the certain radius of the Cacher. Just don't kill them but use them instead. Some details are in previous videos.

[@kasiakozowska7254]

@@JB-20 For many years I have been observing and collecting all the information on this subject. Unfortunately, I do not have 400,000 Euro as Kapanadze wanted. I'm also curious about what's inside the blue rose. I will be grateful. I'm from Poland.

[@JB-20]

@@kasiakozowska7254 Me either in several years keep researching and still experimenting but by own understanding. Lots of people complaining Kapanadze for the payment without any working device arrived, not sure them though. What I'm doing is experimenting by own analysis about this technology hoping to get any success.

[@dkdyker]

Hi Jb , so I can see that the output coil is collecting the field around the earth cable and being increased by the spark gap. Yes the earth through the center as we have done before but just not had time to see :) thanks .Now this could be tried in other coil arrangements. What is the wattage of your bulbs?

[@JB-20]

By having the Earth cable at the center or outside the coil seems no difference from my observation so far. Bulbs are 230V/ 40W each.

[@JB-20]

I tried making the Kacher run slower upto 50Hz by using an interrupter but seemed not a good time to chop. Maybe running at high speed and converting the energy to DC before we chop the stored energy at the cap bank. I have a plan to add a coil and to be driven by lower freq like a push-pull or a zvs.

[@rocioalvarez7853]

Subtitulado pls español? Muy interesante

[@rndport.portela2132]

Miito legal voce pode compartilhar o esquema?

[@JB-20]

Yeah sure I'm preparing for the video. But this setup is in development.

[@MrGeraldino250]

Schematic for replica

[@MrGeraldino250]

Audio bad bit good work

[@mohamedmohamed-nc5fi]

ممكن شرح اكثر اخي

[@user-ov7pb7mq9e]

чего там внутри катушки то?

[@JB-20]

What is inside the coil is also a coil. A coil with fine wire like Tesla coil secondary.

[@valeriysvan7066]

@@JB-20 И намотана она встречно верхней катушке. Здесь работает принцип эфирного вакуума, когда касаешься проводом заземления, то из него проскакивает искра тока, это хорошо видно.

[@kasiakozowska7254]

Scheme please.

[@JB-20]

It has simple scheme but will make a short video when I get back home.