Throwing a Flat Bottomed Oval Pot on the Potter's Wheel!

[@pamboone4458]

“Make your craftsmanship intentional” I need a poster on this😆Thanks for sharing!❤

[@KaransPotsAndGlass]

Ohhhhhhh, Gosh- I need that too!!! 😂

[@jutakis]

I love this concept of bottomless cylinders! Thank you for showing us another amazing idea!

[@Syllacrostics]

The QR code on the slip bottles is such a clever idea!

[@KaransPotsAndGlass]

Thanks!!! I have QR codes all over to help kids help themselves!!

[@lorihry6236]

What a great idea!

[@mariesara]

Great idea! And how would you do a lid?

[@KaransPotsAndGlass]

I normally make the lid something like the base, but just a little over the edge, then I would put a flange on the interior- probably a thrown flange- that fits within the piece.

[@theexpotition]

When you're stretching the bottom slab into an oval, does the original width/diameter narrow at all as you elongate it? Or does it tend to hold the same width? Wondering if I should throw it any wider than the wall to account for that. Hope my question makes sense, thank you!!

[@KaransPotsAndGlass]

That's a great question!!! I would say generally, it stays about the same width. I usually make it a smidge larger and trim away the excess, so when I do that it doesn't truly matter!!

[@theexpotition]

@@KaransPotsAndGlass That makes sense, thank you so much!

[@Stella-ys8qh]

Vous ne faites jamais de petits colombins à l'intérieur et à l'extérieur pour renforcer la soudure du fond des plats ?