Kawasaki Mule No Brakes - Complete Repair

[@3d_discounts807]

Thank you sooooo much for explaining putting the drum back on. I replaced my CV axles and got stuck on putting the hub on. I had to do an unplanned "brake job" to complete. Great video.

[@CopperBarnHomestead]

Thank you for watching and your awesome comment! Glad it helped out. Have a great day and be safe!

[@timhall5226]

Good job, video.

[@CopperBarnHomestead]

@@timhall5226 thanks for watching and your comment! We appreciate the support! Have a great day and be safe!

[@johnwoody4905]

Good video and job yes sometimes old school way works best. Sometimes if you let them set over night air will work it's way to bleeder. Take care be safe and well.

[@CopperBarnHomestead]

Thanks, yes I have had decent luck with the overnight gravity bleed too. Have a great day and be safe!

[@jonathonboss350]

Very good video. I will attempt a brake job on my mule now.

[@CopperBarnHomestead]

Thank you for watching and your comment. You can do it for sure. Let us know how it turns out. Have a great day and be safe.

[@erikgreve6025]

Nice video with explanation! 👍 wish you would have done the emergency brake (rear drum).

[@CopperBarnHomestead]

Thanks for watching and your comment! I have thought about doing that also, the e brake works on this mule but I could definitely show adjusting it and how it works though. Thanks for your input, have a great day and be safe!

[@rodkramer8879]

Do you have any idea how to adjust the parking brake on these. I own one and need to tighten the parking brake some.

[@CopperBarnHomestead]

Thank you for watching and your comment. The parking brake is adjusted at the rear wheel by tightening a 12mm bolt from what I have seen. I will look at ours tomorrow and update if I see anything different. Have a great day and be safe!

[@rolandgutierrez813]

thanks for the video , thats pretty basic , i thought you were going to have to replace the master cylinder , kawasaki has had alot of problems with them going out . other than those Lug nuts being on there too tight !

[@CopperBarnHomestead]

@@rolandgutierrez813 thanks for watching and your comment. Yeah I originally figured it was a master cylinder, was happy to find that wheel cylinder honestly. Have a great day and be safe!