Kenmore 700 Series Washer (Diagnostic mode)

I would show the viewers that I want to show them how to put on Diagnostic mode Kenmore 700 Series Washer. and yes, this is my Great Aunt's Kenmore Washer. so basically, it does work with 2015 Whirlpool Cabrio for every test mode. I hope you like it!
©Ryan’s Washer Videos 2022

[@user-gq6iv1xf4m]

Funny how i remember being a kid and have an old ass washing machine that never had any problems. Now they start making them digital and the problems are endless. I might see if i can find an old one again

[@sammyg1631]

I used to fix my Kenmore washer and dryer everytime a part wore our or some other issue (not many overall). Loved that they were dependable and that I could do the repair if needed. Sadly we replaced the washer when it beyond my ability to repair and bought a 700 series. The lock problem is the most prevalent on it and now it keeps skipping to Complete a minute after it starts. Too frustrating. Miss that old washer!

[@ibarrafamily]

i have the 700s kenmore and it finally started doing this after 8 years. so thats why im here. thanks bud im haveing an issues with it not spinning now.

[@MrsKatherineLBrown]

Thank you! You helped me

[@MoonmaidMama]

Same machine mine says E3F5 I read somewhere something about the locking mechanism but how would I go about checking? How did you get this into diagnostics mode? You went very fast on pushing the buttons.

[@pony7124]

Could you do the sanitize cycle if you can on this machine?

[@kacey6402]

Ran diagnostics and it failed 005 which it is the pressure sensor. How do i open the control panel to replace the sensor?

[@sonicosonicollc271]

Hi! By any chance do you have a video on how to factory reset the board? My machine steam is not working, what could it be the problem?

[@RomanOthelloWilliams]

That ding sounds Maytag's ding

[@tedprater64]

I have this same machine it only will fill to about 5 gallons on normal cycles does this machine have a load sensor and if so where is it located also the pressure switch is mounted on the main board and doesn't seem to have a way to adjust It can anyone help with this it has no error codes

[@applianceflipper8590]

Nope lots of complaints on this machine some complaining that some clothes don't actually get wet during the wash cycle. What people are doing now is adding water manually.

[@dannywilson850]

How do you test the water level. Mine seems to have a low water level when washing

[@hotgirlbummer520]

Same

[@applianceflipper8590]

@@hotgirlbummer520 That's the complaint you'll have to add manually.

[@mayragonzalez502]

Same to me it only use like 2 tablespoons of water I hate this washing machine..

[@applianceflipper8590]

welcome to the new washers @@mayragonzalez502

[@tonyruiz9673]

I tried the diagnostic and mine says E2/F5 and tips or suggestions on what I can do?!?

[@user-qz5pe2pe6u]

Lid lock

[@arlenrpillado]

I have this machine and it's got code f7 and E9 what do I do and what's the issue.thank you

[@user-qz5pe2pe6u]

Locked rotor

[@jimmybalboa8602]

Tengo una labadora Kenmore 600 pero el sistema no funciona solo ase un sonido como q BA alabar que ago

[@Warp3326]

I have the dryer version

[@hrivers78]

Same washer but mine dosent seem to be getting the clothes clean. Maybe not Agitating

[@applianceflipper8590]

No not enough water add water manually.

[@mayragonzalez502]

Same happen to, it's like is washing with like 2 tablespoon of water...

[@alfredoandrade5302]

Tengo una que no deprime que ago

[@janicegwilson-qv5zq]

My machine keeps saying f5

[@wendycampbell6752]

I have this same washing machine and it just stopped working. After I push start I hear the lid lock and the basin starts to spin but it’s making a knocking sound and hardly spins very slow, so it doesn’t even get thru the process of weighing out the load or adding water and the knocking sound is pretty bad. Water never even begins to fill up the basin and after a few attempts to spin & weigh the load, the machine just shuts off. Don’t know what’s causing this cuz I know nothing abt repairing these types of machines. I watched your video but I’m not sure how to initiate such a test. If you have any advice that would be great & super helpful. Thanks

[@SergioGonzalez-qu3vv]

i think is the washer drive belt ,is in the bottom of the washer .

[@DylBuilder1]

@@SergioGonzalez-qu3vv Not the drive belt. these machines are direct drive.

[@kellym4753]

Any update? Mine is doing the same

[@applianceflipper8590]

@@kellym4753 suspension springs

[@HeydaCarreras]

@@SergioGonzalez-qu3vv Don't say shit. it doesn't have any belt

[@robertlarrymclin6939]

My 700 series Kenmore is not starting

[@jennyfersanchez6057]

I tried test number 10 but the washer is not spinning, what would that issue be?

[@DylBuilder1]

Shift actuator, unless the machine is not agitating either that's either a dead motor or capacitor. the capacitor and shift actuator are fairly cheap to replace so that would be where you look first.

[@eriksarizky8114]

Samsung WW900 washing machine end tune

[@charlotteharper1565]

Where did you get that magnet?

[@ryanswashervideos6052]

I found it on the other side of her fridge. So this way I can defeat the switch

[@snagswayne1]

How do you recalibrate the washer

[@joeradke7522]

@@ryanswashervideos6052I can’t get the machine to bypass the lid lock with the 🧲

[@ryanswashervideos6052]

@@joeradke7522 if the magnet can't fit into the lid lock switch, you'll have to find much smaller to fit it in, so that way you can bypass it. but remember, push the lid lock latch halfway, so that way it won't cause an issue

[@joeradke7522]

@@ryanswashervideos6052 bought new switch, good as new

[@laundryandtrainman2467]

On the test mode, the clothes would have the worst rollover with the agitation.

[@ryanswashervideos6052]

if it's too slow for agitation, they probably won't come out that clean. even strong agitation can clean kind easily

[@SergioGonzalez-qu3vv]

cdn.appliancepartspros.com/images/product/cache/frigidaire-washer-drive-belt-134511600-ap3867042_01_l.jpg

[@marycore4437]

Que significa E6 y F8

[@JSmith-Not-Smythe-Dear]

The Wash Temperature is at Hot The Soil Level is at Extra Heavy The Spin Speed is at Max Extract Options Selected are Oxi, Extra Rinse, and Deep Clean. Audio Level (High, Low or Off) is optional.

[@jasonroth5268]

Basket frozen after spin cycle

[@JosedorantesGutierrez-pk9gw]

SI jalo la labadora