Kenmore 80 series, Stop spinning, replacing drive basket and clutch!

[@jeffersonofficialchannel2034]

Thanks for the idea you share sir👍

[@jlamb199]

I could probably replace the clutch but taking out the transmission might be a bit advanced for me. Thankfully the tranny still works! So far I did the water inlet valve and today I finished the drain pump. Two laundry loads & one with AFFRESH. I'd call that a success!! No more appliance videos for awhile, I gotta decompose!💀🤕💀 THIS one, however, I'm just watching for the "BOB ROSS EFFECT"!😂 Thanks for everything!!

[@allanautollc3210]

Good work!!! Nothing is too complicated with these particular washing machines. Just the weight of it. If you ever run across a free washing machine or Dryer, experience taking it completely apart. You'll gain more knowledge.

[@jlamb199]

@@allanautollc3210 Aww, thanks! I feel kinda proud of myself. Most girls just get on the phone!😂 Take care, Al!✌

[@adanbautista36]

My exact same problem. My on spin cycle is making grinding noise. And the c clip is not holding it comes out when you turn the brake . Yours was making a grinding noise too?

[@allanautollc3210]

@@adanbautista36 clutch assembly and the little couple on the motor shaft