KingSong S22 motor replacement

[@Euc_spirit]

Sure. The Motor Screws are way too tight to skip this issue!!! Sad. But only a S22 Rider will know.

[@AG.Floats]

Easy tire change TBH Most wheels twice the time and screws before even getting the damn thing out just a little bit. I'm done with plastic shells. All I have to do to mine is tighten down those 4 screws on the slider bracket on both sides. Just became loose.

[@vincentkim2721]

Oh very good ^^

[@dirkschelfhout6460]

The screws at 1:57 don’t come off. Pretty sure I use the proper tool. At setting 16 thescrew driver blocks. Disabling that it ruins the screw. Using an allen key hand tool doesn’t do it, it almost feels like it would snap in my hand.

[@skobuffs7]

did you figure out a way to remove those screws?

[@dirkschelfhout6460]

@@skobuffs7 no, but there is another way for the wheel to come out. Then I had to remove the 8 screws on the motor wheel. 2 were hard, i didn’t have a heater.so hitting on it with a hammer gotvthem out. Now I am waiting for the spare parts they send me. They failed to send by express so will be long wait.

[@dirkschelfhout6460]

Following this : kzbin.info/www/bejne/jnjGe6yPoL2qr9k

[@dirkschelfhout6460]

My brand new wheel had a 1-2 mm splinter kind stone inside between the inner tire and the rim.

[@milordas]

8:51 i would realy replace those philips bolts to hex

[@dirkschelfhout6460]

Getting that small black cable under the wire cover at 8:44 was no fun. There should be more space under the cover.

[@dirkschelfhout6460]

I don’t see any glue being applied to the screws when recassembling. Is the glue still on it ?

[@mikemelroy1424]

I'm getting an error code 17 and I just replaced the motor with a new one. Is there anything else that could be giving me that error?

[@Juicey808_euc]

After I install the motor. When I turn it on. It spins the tire. Is that normal? What do I do after that?

[@slidersgliders5516]

The suspension sliders are a bad design. Poor quality , mine has dust already after a few days riding.

[@noelleonard2498]

when the grit scores the channels that are also the battery cases it won't matter how many sliders you replace. shoddy design

[@noelleonard2498]

something that should never need done.

[@SolarizeYourLife]

This is a sad show how not to do a suspension wheel, and look at the complete tear down just to get at tire!!! What a nightmare...

[@pR-cv4iu]

It takes 15 minutes to drop the motor with three tools, how is that a nightmare?

[@Oraclereason]

I think that comment is envy speaking. For an EUC this is fairly straight forward. Not a nightmare at all