Klipper on Duet3 mini 5+

[@tapirath]

since it's been a while you have switched to klipper, can you tell any obvious advantages klipper has? currently contemplating to do this

[@tkneglock6399]

I have the same board, so I tried Klipper but didn't understand the procedure. disappointing

[@uepsie]

I am very interested in how you got Klipper working with the duet 3 mini. Would you mind sharing your steps?

[@LukesLaboratory]

github.com/KevinOConnor/klipper/pull/4133

[@uepsie]

Cool! Thanks!

[@AndrewAHayes]

What is the ABL sensor you have on the printer?

[@LukesLaboratory]

Standard inductive sensor - 8mm diameter, 2mm sensing distance. Probably should have installed a 4mm to account for wayyy-out of alignment beds after I mess with it by hand, but shouldn't be important for constant use