I tested Kor5 D12 /36 R0,75 mill 1.4301 with dinamic milling. It was good but not enough. Parameters: Ap=18 mm Ae=0,6 mm Vc=220 m/min rpm 5800 Vf=2356 mm/min Cooling emulsion My question is it ok parameters for Kor5 and suggest not using cooling only air?
@mattysee243 ай бұрын
Whats going on with the flutes in the shank?
@NasihinnurIsmail8 ай бұрын
Can give advice endmill to cut stainless steel welding
@ryanbeard1119 Жыл бұрын
You don't really mean conven milling where the chip starts thinnest and thickens? You just mean the more convein z fixed toolpaths, right
@frankwoodall61984 жыл бұрын
Kennametal your tools are fucking boss. Mega turnin = mega earnin do you guys by chance make coated solid carbide boaring bars? For smaller diam. ?
@dimasroy50404 жыл бұрын
Semi Finishing Endmill ,Right
@stevegeorge73884 жыл бұрын
These can all be used to rough, semi-rough, and even finish. The chip breaker pattern has a large enough pitch so that they do not overlap, so they also work very well in finishing if you have to only use one tool.