KT200II - Read and Write Sagem S3000 ECU ( J-Tag & Boot )

[@irfankhalifa5647]

Thank you for your videos very helpful... Is there more protocols with KT200II than Foxflash?

[@UnixCoDElectronics]

I`m not able to say because i don`t own a FoxFlash device.

[@mishokorlov]

Good video thanks👍 Over all would you recommend to buy Kt200II 🤔

[@UnixCoDElectronics]

Hi, yes overall its a good tool for read / write ecu mods files, its not good to clone edc17 ( due to OTP area cannot be skipped )

[@mishokorlov]

@@UnixCoDElectronics I guess for edc17 PCM flasher would do good job 🤔

[@UnixCoDElectronics]

@mishokorlov yes, PCM Flash its an awsome software, most of time i use it for Bosch ECUs

[@mreepromer4977]

​@@UnixCoDElectronicsfor clone edc17 must enter special menu then it can do otp too

[@mishokorlov]

@@UnixCoDElectronics Did you use 77 module for edc17?

[@reirizjose]

hi, is it safe to do the checksum with this tool? thanks

[@UnixCoDElectronics]

Yes, all the time when i let the tool do the checksum was ok, without problems