Kubota SVL Skid Steer: Easy Glass & Polycarbonate Door Installation Guide | AmeriRent Equipment

[@1diazj]

Thanks I live in des Moines were i buy 1

[@wrfarms9741]

Would you PLEASE make a follow up video for this video on how to PROPERLY adjust the door if it is out of adjustment or in my case, the Kubota dealer installed a polycarbonate door glass just like this one and screwed the door adjustment up BAD. I have had it back to the dealer twice to fix the door adjustment but each time it just comes back to me worse! Thanks!

[@AmeriRentEquipment]

What exactly is going on with the door?

[@wrfarms9741]

@@AmeriRentEquipment The door would only latch in the up position on the left side and there was a LOT of clearance for the door to rattle around in the up position. Today, the Kubota dealer sent out a field technician and we tried adjusting the up stops which seemed to help a lot. What perplexes me is that there apparently is no lock nut to set the up stops in the new adjusted position and they rattle when the machine is in use. As far as I could see, there were no lock nuts or anything to set the up rubbers stops to hold their position. Are there suppose to be? Or do those stops just sit there loose like that? Doesn't seem right.

[@wrfarms9741]

@@AmeriRentEquipment The door would not latch in the up position on both sides. I watched this video today which gave me some ideas. The Kubota field technician met me at the work site and we adjusted the up stops. They were way out of adjustment. The door works better now but the up stop rubber bumpers apparently have not lock nut or mechanism to hold them in the new adjusted position. Is this normal???

[@AmeriRentEquipment]

@@wrfarms9741 Yes there should be lock nuts that push against the ceiling once the rubber boots are set in place to lock them and keep from moving.

[@wrfarms9741]

@@AmeriRentEquipment Thank you! I will go back and have another look with my glasses on. LOL! You would think the Kubota mechanic/technicians know this. 🙄 By the way, I am now subscribed!

[@kingkustomsandperformance2549]

There is no audio at the end… would be nice to know what to set the bumpers to…