Рет қаралды 234
This video demonstrates how to place surface jumper wires between different parts of a PCB.
Two techniques are shown: bare copper foil traces (good for short, high density runs) and insulated wires (good for longer runs or high current). The bare trace is insulated with 2-part epoxy and the wire is attached using ultraviolet-cure polyurethane.
References:
* www.circuitmedic.com/guides/4-... (foil jumpers)
* www.circuitmedic.com/guides/4-... (insulated wires)
Thixotropic epoxy: www.atomadhesives.com/AA-BOND...
Uv polyurethane: www.ellsworth.com/products/ad...