Land Rover Discovery 3 lr3 Rear wheel bearing replacement.

[@ZachBrimhall]

Shoes at least, maybe some pants... basic protection... just suggesting but thanks for sharing

[@marcioschilling954]

Lock the suspension in access height before anything else.....

[@fredsorensen7971]

Just replaced mine now dash it lit up an suspension don't work any ideas would be greatful

[@normanwalker-worth3039]

Hi, I have replaced the near side rear bearing, to say the least, it was a nightmare, this being down to not having the special tool that Land rover garages have ...have watched your video (excellent, one might add), you motioned you do not have the Land rover jig either, The part where you pulling the hub out of the bearing with the axle yoke still attached is not clear! ...can one ask what jig you have used, perhaps a better picture of this would be great ...no doubt, there will be other's over here in the UK that would seriously benefit from this, so, any chance of more detail? ...again, thank you for sharing your method of removal ...Regards Norm's

[@graemevass745]

Does it matter what way round the new bearing goes in ???

[@gatdammit]

Thanks for the video... Where'd you place the jack to lift the vehicle?

[@JonCianci12]

gatdammit under the rear differential. Once it's up support the car with Jack stands under the chassis

[@scrotesack]

Can't watch that. Camera moving all the time makes you feel seasick

[@ksasbr107]

Hello , is there easy way to change the rear bearing hub ? I though it's an easy job to do it !! Thank you

[@JonCianci12]

ksasbr107 the hardest part of this job is pressing out and in of the respective bearing and reassembling the park brake, if your not in a hurry, it's not very hard.

[@ksasbr107]

Jon C hello , I mean I saw another video changing the hole bearing hub and put new one straight forward job . Or is it different in the back wheel ?

[@ksasbr107]

Jon C very helpful video , 👍

[@JonCianci12]

ksasbr107 it's a different process to the front. in some ways the front is easier.

[@torbjornlindh5108]

Hi, how big is your presse? I've seen claims that a 30 tonnes is needed, and some that it takes a 50 tonnes

[@JonCianci12]

Torbjörn Lindh I think mine is about 10 ton. it broke free reasonably easily

[@torbjornlindh5108]

Jon C Thanks! I tried it with my 10 ton press, with the same puller tool you used for the collar, and it all worked out fine. It was close, but it worked. Thanks for this great video!

[@JonCianci12]

Torbjörn Lindh great to hear! not to bad a job, just need to think each step through

[@benzman113]

With the size of your tools looks like you repair excavators.

[@umarshahab7725]

HE don’t know How to work on the car, he Will loose screw for rotor hit with impact, spouse with the correct tool

[@raggytigger217]

Couldn't watch, camera waving all over the place making my eyes hurt.

[@LinaresEnterprises]

dude. around 7:40, not once is there video shown to take out the ring that covers that cable and not to mention the audio is barely hearable. don't upload videos that have no help or steps to fix something like this.