In this episode I repair the rusty bulkhead on the Land rover
Пікірлер: 16
@LittleshopofFredrik6 жыл бұрын
Great work, looking forward to next episode!
@lookcreations3 жыл бұрын
Great repair 👍
@AverageJoe20206 жыл бұрын
Spot on, It's good to see a thoughtful repair done, If you are going to wax inject it (AFter paint!), The best stuff I've used is from Dinitrol. Cheers, J.
@machineshopatthebottomofth32136 жыл бұрын
Thanks,I have some waxoyl that I will spray in, may not be the best but it will do a better job than nothing!
@AverageJoe20206 жыл бұрын
Waxoyl does the job okay, Best if squirted in hot into warm panels, though I know I do not have to say that to you. Please keep up with the updates of what you are up to, There is too much BS on the web, a bit of practical, pragmatic repair is good to see, Best regards, Sam.
@centaurc-o2o6 жыл бұрын
Very nice refab. Would injecting those areas with rust preventing insulating wax spray be a good thing to hedge against this happening prematurely in the near future?
@barney4536 жыл бұрын
Nice job!
@tpantazopoulos6 жыл бұрын
outstanding job
@pearcemachineshop52006 жыл бұрын
Great channel.
@conrad14686 жыл бұрын
Nice work!
@busman20004 жыл бұрын
There's gaps in the first lot of welding, you could drive a bus through. To be water tight and structural it must be a continuous flowing bead. Looks like a skinny caterpillar.
@machineshopatthebottomofth32134 жыл бұрын
when I cleaned it up it was continuous, no gaps
@stuartsturgess2199 Жыл бұрын
did you weld up the drain hole on the windscreen support ?
@machineshopatthebottomofth3213 Жыл бұрын
no still there, just now the original size!
@steamwally4 жыл бұрын
I notice the steering box is already out, how did you get on removing it with the brake master and servo in place?
@machineshopatthebottomofth32134 жыл бұрын
did not pose to much of a problem, access was easy as most of the rest of the components were removed