Lane Regulators - Pt. 2-4 Transfer Port Size Adjustment.

[@robertlanedesign]

Yes: We always do, otherwise you still have the restriction of the hole closing up into the barrel. It can be a bit of a pain to do if the rear of the barrel (Breach) is multi-part i.e. two - three brass pieces with an O-ring insert. You have to remove the O-ring and be careful and de-burr well. If it is a solid steel barrel at the breach, we some times cas some molten lead into the back 1" 20mm of the barrel and drill through into that to stop burring.

[@krustyoldsmoker7997]

Yes sir you have to make sure you have the right drill bits Sharp and start small and gradually go larger with your drill bits I just got done doing my flashpup a couple days ago use a drill press I did a real slick job y'all have a good shooting day bang bang bang

[@NorthWestAirgun]

Question for you; do you need to drill out the port opening in the barrel to the same size as the transfer port? Really enjoy your series of videos, learning a bit too!!! Thanks.

[@ronnywidjaya1848]

how many milimeter diameter of transfer port needed to carry 16 gr pellet at 1300 fps. is this possible?

[@junglie]

it's a waste of time accuracy goes with lighter pellets after 900 fps. power is no use without accuracy.