Lasfit LED Tail Lights Installation - 2017 SUBARU FORESTER XT

[@slowandlow6829]

I dig your tutorials bro ... you give me lots of confidence to do this to my 17 Forester .... thank you for this 🔰🙏

[@danek893]

Cool, i got ALLA LED reverse light on, it does blink couple time before it bright up, kinda cool idea just to give attention to peoples around that i'm reversing.

[@FOZ23]

I like ALLA Led. California based company and good customer service. I had defective led bulb and they replaced the one bulb basically hassle free

[@enesex]

You don’t need that trim tool the taillights actually just slide back towards the rear...just takes a little wiggling

[@TheHumanCarJack]

gotcha!

[@williamreynolds6132]

Yeah, lucky you didn’t break the clip going the wrong way

[@colonelcasey87]

Nice install video. Just change out your tail light/rear side marker bulb with a red 194 LED and you'll be done with halogens! In the back at least.

[@williamreynolds6132]

How they look from two feet away is nice but you should back up a little, like the distance a car would be from you. Also it would be nice to see the beam pattern and range so you could face away from the car for a good night comparison.

[@bill6960]

Touching the oem incandescent signal lights isn't going to hurt them. They don't reach the temperatures that halogen and HID headlights/fog/driving lights do. The high temps and the oils from your skin will shorten the life of those. If they got that warm, the marker lights would melt the housings.

[@michelsilvacosta1932]

🔝

[@cbijames7]

You what sucks my 2021 subrau forester they increase the wattage on the halogen bulbs to 28 watts. So I had to put resistors in and they still hyperflash a little then blink normal after a few seconds. It's crazy.

[@scomoore1951]

Rehearsal would help.

[@jeremycortese]

How are those turn signal LEDs not hyper flashing?

[@CChris08]

Worth the upgrade 👍 Don't need a relay module for the turn signals?

[@TheHumanCarJack]

I think so and nope!

[@goggiwalnuts]

I was was going to ask just that, due to less voltage, most cars will blink much faster if there is no resistor

[@irbeast69]

Yes you do. I changed out all my bulbs, front back and they blink really fast. It’s annoying, considering putting back the original halogens

[@antonroshonok4412]

Turn signals will not work correct after that upgrade , clics like crazy(, need resistor or relay

[@X_x_lxx]

Is there an installation video of the front turn signal?

[@ricoibarra1]

use duck tape instead of the plastick panel remover. works so much better.

[@TheAntonMon]

How do you know which light bulb number are they? After watching your videos. Imma going to try swapping my halogen bulbs out too. Forester SJ Turbo trim XT 2014 model.

[@TheHumanCarJack]

Check the link in the description. Just type your car into the search!

[@kingshonen]

Hi how did you over come hyper flashing issue with the amber led turn signals? Did u have to wire up load resistors for them both? Did u change the front signal to t20 led as well with load resistors? How much for the amber leds?

[@TheHumanCarJack]

I just replaced the bulbs haha link in the description to the bulbs

[@leemoore8154]

I read somewhere that the stock relay in the 2017 Forester takes care of hyperflash. It also introduces the tap to turn (three blinks for a quick tap of the turn signal stalk), so it's definitely different than previous relays.

[@philiptan2686]

does normal led bulb will do, or i need to buy a canbus type lud bulb???

[@nikolavonfulton5195]

Do you by chance have the link now. At least to there store

[@harshavk1096]

Hey bro did you use hyper flash module to avoid cashing on Turn signals???

[@TheHumanCarJack]

not sure what that means bud

[@leemoore8154]

I read somewhere that the stock relay in the 2017 Forester takes care of hyperflash. It also introduces the tap to turn (three blinks for a quick tap of the turn signal stalk), so it's definitely different than previous relays.

[@52hydra]

@@leemoore8154 Is this confirmed?

[@bill6960]

For the older model years, you can use the Toyota flasher unit. It looks/plugs in the same, but does not have the bulb outage feature. I have all LED lights front and rear in my '10 Impreza. No hyperflash. I was curious about this, as I have been considering LED's in the '17 Forester. Good to know nothing extra is needed, hopefully going full LED's front and rear.

[@en3rgy187]

Awesome!!!!! I'm a new subscriber. Can you do a hella horn install sometime? Also maybe front turn signal led install too?

[@TheHumanCarJack]

Welcome! I've got the Hellas installed but didn't manage to film it

[@en3rgy187]

@@TheHumanCarJack awwww :=( that sucks. Any chance on getting a recap of it showing your finished product?

[@SpottedOnTheRide]

Good thing I won't be blinded by those since I'll be ahead of you 😋 haha

[@TheHumanCarJack]

Got eeeeeem

[@cfischrun115]

Touching the bulbs will not break them...

[@TheHumanCarJack]

What if I breath on them? Surely they'll break

[@DronieUp]

Any hyper flash issues?

[@TheHumanCarJack]

Yep, changed em back to stock

[@avipro737]

Thanks for another nice video. Can I please ask you for the part numbers as I have to buy them from Amazon as the eBay seller will not ship to me :( (would appreciate all the part numbers of what you have installed as I will do the same to my XT) Cheers, Peder

[@Emma-un8mf]

What's your address? You can contact ebay seller, and you can get discount

[@avipro737]

Well, I live in Sweden and they don't ship here but if I have the PN I can get it from my supplier locally.

[@brianpendleton4898]

Any issues with hyperflash

[@TheHumanCarJack]

Nope!

[@isreal194]

You can put an inline resistor to make the hyperflash go away

[@musicISlyf1]

Your link isn't valid

[@irishknight5386]

What size sway bars did you go with on your Forester?

[@vonveloso]

How'd you black out the chrome inside the tail lights?

[@TheHumanCarJack]

I didn't black em out lol

[@vonveloso]

@@TheHumanCarJackI see the dark colored car next to it, guess it's the reflection. Black out the chrome, do a video