LDO Voron 0.2 Build - Electronics & Wiring

[@Shenandoahleather]

After watching your vids, my 0.2 is ready to go but for one thing. There is no way to power the Rpi 4B. I don’t see a way to add the top hat you mentioned. Maybe LDO has the wrong part in my kit?

[@gunplamark]

The hat just fits onto the GPIO pins on the Pi. The photo in the LDO docs - docs.ldomotors.com/v0s1_wire_guide/rpi_z2w_prep.jpg - shows the hat installed but it's on a Pi Zero, so that won't be exactly the same as the Pi you have. I can try to grab a photo of the Pi in my built v0 tomorrow if you think that would help.

[@Shenandoahleather]

@ I found it. I got on Discord and they helped me figure it out. One of those parts that gets lost in the shuffle. The last piece I have is the Z end stop. Mine came with the three terminal block unlike yours that has two terminals. But, LDO doesn’t say which wire to put on which hole and polarity also is not specified. I also don’t have a two lead connector end to use. Would you have any suggestions? If not no worries. I may end up ordering a two end connector if all else fails and do what you did to get around it.