This short video explains the programming of on-chip LCD driver on STM32L4. Visit here for more information: web.eece.maine.edu/~zhu/book
Пікірлер: 13
@krish2nasa7 жыл бұрын
A crystal clear explanation, many thanks to Prof. Yifeng
@dabdoube922 жыл бұрын
I see what you did there
@vishrutdave67143 жыл бұрын
You saved my day, quite literally.... I found this video extremely helpful for my new project
@embeddedsystemswitharmcort90513 жыл бұрын
Great to hear!
@mityastavropolev31825 жыл бұрын
Super! Very clearly. Thanks a lot!
@ramimehyar4812 жыл бұрын
This is low level embedded explained perfectly!!! What books or materials explain embedded at this level if i want to learn more?
@Jarrod_C5 жыл бұрын
at 11:48 the diagram shows the LCD pin 15 is connected to PA9 yet in the yet you say pin 3 is connected to PA9 when it should be PB1. I am pretty confident this is a mistake.
@HammadKhanYT6 жыл бұрын
Great explanation but I am confused about biasing. There is 1/2 bias, 1/4 etc, which one one goes for and does it really mean (in waveform etc). Can you please reply?
@embeddedsystemswitharmcort90516 жыл бұрын
Does this link answer your question: www.pacificdisplay.com/lcd_multiplex_drive.htm
@SuperUriele3 жыл бұрын
very good the tutorial helped me a lot. however I can't finish getting the lcd working. I load the data into RAM, activate the UDR and turn on the LCDEN, and still no image appears. I am using a STM32L152RTC6, what else can I do?
@embeddedsystemswitharmcort90513 жыл бұрын
Any segment shows up at all? If none, I would focus on LCD settings. If some, I would focus on GPIO settings of each pin.
@James-ss9hi10 ай бұрын
great
@rahulkamble83733 жыл бұрын
plzz make the same video for interfacing TFT LCD with STM32 microcontroller.