LEE Pro 6000 Modification of a Modification

In this video we take the modification of the case feeding spring one step further. A much better improvement on my previous modification.
Here is the video to the previous modification:
• Yet MORE Modifications...
Be sure to visit my web page for more "Garage Entertainment"
www.rvbprecision.com

[@leadpilled5567]

I use powdered graphite. I have it on the case slider ramp and on the primer slider and trough. Very very small amount spread it with a tiny paint brush then hit it with a bit of compressed air. I have the silver layer bullet and case feeder and I put a bit in the feeder tubes then ran a couple patches with a cleaning rod and bullets and brass just fly down the tubes now

[@mr.horseshoe2301]

Great tip! Thanks for sharing your modifications.

[@alanddeb2]

Great info, thanks for posting. There's always new ways to improve on this fine press. Keep up the good work..

[@chrisviking428]

Thanks for the tip!

[@mattfinleylive]

You're the man!

[@indyvin]

The reason Lee uses a spring instead of a solid rod is because if the primer or case feed sticks, the spring will buckle or elongate before any parts are broken.

[@roybertalotto6355]

Yes, it still needs to "stretch" but it does not ever need to collapse. Very poor design made better with a simple addition of an aluminum tube over the spring. Thanks for watching. Appreciate it!

[@timoxford5124]

Sir, have you figured out how to use a silver layer case feeder on the 6000.....please do a video of that, thanks

[@roybertalotto6355]

search my videos. its there. search Roy Bertalotto

[@SlickNick1818]

Hi, I am tired of buying new springs can you tell me the exact dimensions of the arrow shaft, length and diameter, please and thank you.

[@roybertalotto6355]

Use a 1616 or a 1717 arrow shaft. Available at any archery shop or on Amazon. Or send me your email address and I'll contact you and I'll send you a few. Just cover shipping cost.

[@roybertalotto6355]

rvb100 at comcast dot net

[@jeremymolyneaux5025]

I cannot get my press to progress after I changed the plate to 223 I have to puss the plate to progress it to the next step. I'm totally lost

[@roybertalotto6355]

Might want to reach out to LEE to see if they can help. Good Luck!

[@stevenbarbee1367]

Good video. May I ask what length you ended up using for the 16-16 arrow modification?

[@roybertalotto6355]

Never measured it...But I just did...3.80"