Lego Pneumatic Engine 2 Cylinder

www.1nxtmonster... A pneumatic engine I made. 2 large cylinders, with slider mechanism. The valves are actuated directly by the sliders, so it is a quite simple setup. No parts were modified. Run at 40 PSI

[@VCLegos]

The T`s will hold up to 70-80, if you put them on right. the switches and pistons are where they pop off for me. BTW the non lego air compressor is the only way to do this sorta` thing.

[@BensLegoTechnicCreat]

not bad , it's good

[@bachaddict]

Is it similar to the one in Sariel's book?

[@LegoEngineering]

I decided to build this engine with modified cylinders only. I couldn't believe my eyes! This engine was doing around 1000 rpm!

[@1nxtmonster]

Wow, I'm glad it works well!

[@VCLegos]

I can`t get mine past 40 PSI either.

[@kwon8429channel]

pneumatic ia such as hard thing for me.. So u made engine so can you put it in the car? Btw looks very cool!!!!!

[@royan.jdm2]

Its not really hard, its just about managing air pressure flow in such way that push piston in a right timing & direction :)

[@Oli4vn]

Nice, can you post a tutorial please? And if you wrap some wire around it will hold more pressure!

[@LewaFromRussia]

Because it was too slow.

[@royan.jdm2]

Tutorial please

[@the5Caio]

I build and is very good!

[@1nxtmonster]

Thanks!

[@LewaFromRussia]

I posted the video-answer.

[@LewaFromRussia]

I built the engine like this and it wasn't very good. It was terrble! I advice you to buil I3 or V4 or V6 or V8, but not this!

[@tobiasbachmann9346]

a oter youtuber build this asow