LESSON 3_EXPORT MODEL FROM 3D TO 2D AND MAKE THE SECTION WITH AUTOCAD FORMAT FILE

[@sangphamvan5394]

Video bổ ích lắm cảm ơn anh nhiều.

[@harivibez]

hi sir i need a video on taking view on a particular elevation... for example if a site has elevation of 18m.. in that there are three platforms each at 6m , 12m, and 18m elevation.. if i take lookin D by default it gives whole site and drawing is too lumpsy and conjusted. i need looking D at 12m Elevation and looking D at 6m elevation.. separately please guide and put video on that sir.

[@PDMSFORBEGINNER]

Hi Hari, For taking view on particular elevation, I think very simple in PDMS. You can open draft module then make a view. In this View you can define the coordinate so that can view at 6m, 12m, 18m as you talk. You can follow the step below : 1. Open Draft module 2. Choose General 3. Create Department -> Registry -> Drawing -> Sheet 4. Create View\limit defined. 5. Choose the view has just created above then choose modify\view\limits define. In tap Limits you can define the coordinate from...(W...S...Up) To (W...S...Up). Noted that Up of To is elevation you want to make the view. Before you do this guide please review again this video. I think you can do yourself. Good luck

[@harivibez]

@@PDMSFORBEGINNER thanks sir hope you will put some videos of modelling using commands too equipment piping and structure thanks

[@vienminh8584]

ANH ƠI cho em hỏi , sao em xuất bản vẽ từ 3D về 2D nó lại bị mất các thiết bị mà em lấy từ phần mềm ra , còn những thiết bị do em vẽ thì lại xuất được ạ.🙃

[@PDMSFORBEGINNER]

em kiem tra xem graphics/drawlist trong modul draft co chua zone ma em ve equipment khong nha, anh kiem tra lai ben anh thi xuat binh thuong. Ve nguyen tac khi muon export cai gi em phai chỉ cho PDMS hieu, ở đây là drawlist, phan nay a cung có nhan manh trong clip khi a huong dan cach xuat, em xem lai nha