Lesson 96: Barometric Pressure, Temperature, Approximate Altitude Sensor BMP390 with LCD

[@ElectroPozitive]

I watch your every video, your videos are full of information

[@electronic7979]

Very helpful video 👍

[@tv0571]

If both I2C devices default to 0x27 can the arduino communicate appropriately. Or is there a way to change the LCD or BMP sensor address? Good information in this video. Thanks!

[@apollorobb]

There are pads on the I2C module you can bridge to change the address for the LCD

[@robojax]

Oh boy, I just checked the raw recoding and I have show on screen how to change the I2C address but I missed it during editing. The only way to fix this is to remove the video and upload the new edited version. As @mrAr15 said , we solder the pcb path at the back to change the address. I will post the image in the code page.

[@Micksimpson84]

how would i code it to zero itself (alititude) on power up everytime? Thanks

[@joymakerRC]

THANKS

[@minhnguyenhoang7829]

Nice Video, but can i read it's pressure value at 100Hz

[@robojax]

Link to the documentation page is on the code page. Have a look at datasheet.

[@dalbeerkaur7532]

Hi bro you are great, bro i need your help for writing some ardiuno project code please help me 🙏🙏