Lets Make An Outside Corner In Some Custom Brick Ledge Flashing | At The 509

In this video I am going to show you how I cut a custom outside corner, or miter, in some custom black aluminum brick ledge flashing.
#barkriverknives #fixedblade #cubedc #3v #magnacut #bladesteel #strop #customsheetmetal #seamlessgutter #downspouts #gutter #sheetmetal #shrinkerstretcher #atthe509 #flashing #circletopwindowflashing #sheetmetalhem #spacer #circletopdoorflashing #viral #viralvideo #project #customerorder #sheetmetalshear #scribe #efficiency #jadeg10 #blackcanvasmicarta

[@caleblaughlin8351]

Just want I was looking for! Thx.

[@paulnovak833]

Perfect video. Thanks!

[@Josh-ww5kz]

If you want to go a step further, leave the drip edge piece that you cut off, on there and have the next side of the corner piece cut at a 45, then bend that little tab around the side that has the 45° cut and it it make the corners look even neater.

[@artetaDagoat]

Essentially, it's one piece?

[@Josh-ww5kz]

@@artetaDagoatthe way shown in the video leaves little triangles on the corners, if you leave a tab on it it will close it up and make it seem like it one piece going all around. only a look you can achieve if you leave a tab on the drip portion and bend it around. its only needed when you have that little kick on flashings

[@timallsopp9622]

What about the drip edge?

[@amonjanena3320]

Iman