Liftmaster LA400 with MyQ technology and maglock.

[@bnallc]

Great job. Same setup LA400UL and 828LM gateway, but with push bracket here. Any problems with Homelink pairing with your vehicles? Been very difficult here - apparently Chamberlain changed their controls in 2022. According to Homelink support, you need an LM MC or ESTD MC remote to train Homelink properly. Their instructions worked on a Mercedes, but not on other cars I’ve tried. Fortunately the gateway and MyQ work just like your demo so we have a fallback option

[@briangilberg7663]

I just use the 811lmx. It doesn't work on my garage door but I already have one for my garage door so I didn't want to go through the extra hassle      

[@shak180]

How much did the weld shop charge you for the gate? It looks good. Did they install the gate too?

[@briangilberg7663]

I think aroubd 2500. Yes

[@EbonéPierce]

Where did you purchase the maglock

[@briangilberg7663]

liftmaster

[@briangilberg7663]

From liftmaster

[@antonioozuna1986]

Where on the board did you connect the Maglock?

[@briangilberg7663]

I believe it's the bottom right hand terminal strip. The red and white wire that go into the the green terminal block. The instructions are simple and clear when I read them

[@protectork9831]

How did you setup myq

[@briangilberg7663]

You have to buy the MyQ device that connects to your router that sends the signal out to the area where your control box is by your gate and there's an antenna on the side of the control box and you pair the two together and then it works after you download the app

[@TRUMP-2024-STF]

How do you pair the myq to the controls box.?