Lifts and Levels: READYLIFT 3.5” Lift for '19-'20 Ram 1500s

[@josephmalinowski6817]

it's about damn time you showed some Dodge Ram trucks regardless love the videos and the content in the comments left by the viewers

[@CustomOffsetsTV]

Sorry about that! 😂 didn’t even realize what we were doing!

[@42ambrocio]

They’re just rams after 2009 dawg, they dropped the dodge lol

[@JL-ek2ks]

They haven't been Dodge Rams in quite sometime lol

[@richardpark2609]

I gotta say it's funny that Brad's wearing the Custom Offsets hoodie with BDS Suspension on the back, showcasing a ReadyLift Suspension! Keep them coming guys!

[@CustomOffsetsTV]

Ironic! 😂😂

[@breakies7875]

Love this! Doing it to my rebel to enhance the Steelcraft replacement bumper I just had installed! Gotta make the build complete haha.

[@elfidovigil3282]

Just installed this and the most time consuming was the bump stop spacer, being that it’s hard to get a wrench on the bolt, and getting the top strut bolt off was a pain being that it was recessed and I couldn’t get a wrench on it even after compressing it

[@RAM-BAWN]

I put a 4 inch lift in my last 1500, but I found it was difficult to keep the front end aligned. I would do some research on that aspect before installing one.

[@mikeburr114]

work on rebel??

[@5.0coyotereaper]

Y’all should do a 3.5” Readylift for an Ford F-150

[@jperezjesseperez17]

Is that a Ram!!😎🧐😍

[@josephmalinowski6817]

that looks unbelievably simple is it just because it's 3 and 1/2 in of lift or why is it some lift kits you see them changing all these parts or is it because each tire has an independent suspension so you don't need a change cross bars and everything else

[@johnganshow5536]

But without larger/taller wheels & tires, your axle is the same distance from the ground, so you will hit the same rocks you hit before the lift..

[@mikeburr114]

You need the lift to run the bigger tires.

[@johnganshow5536]

@@mikeburr114 So since they got the lift, are they going to instal the bigger wheels/tires? Duh...

[@390nm]

John Ganshow this probably isn’t going off-road

[@johnganshow5536]

@@390nm Okay then, ground clearance doesn't matter...Still, stock wheels & tires look stupid on a lifted truck..

[@IvanCllzo]

@@johnganshow5536 to you

[@johnmorris77]

I want this lift but am hesitant on sacrificing any ride quality. And the bds 4 inch is well over 2k

[@lesliesmith9233]

Ride will most definitely be worse with any lift.

[@johnmorris77]

@@lesliesmith9233 usually

[@Gucci_Membrane]

I already have Bilstein 5100 lift struts to level my ram, if I install this kit will there be a noticeable squat? I’m not an imbecile and actually need to use my truck for truck things.

[@charliemando6817]

How is the ride quality with the factory shocks and front struts? Should I get invest in new struts and shocks ??

[@CustomOffsetsTV]

It wouldn't hurt anything to upgrade and we recommend it, but the ride quality will be fine without!

[@rockinjohnny1199]

Given that the front and back are lifted different amounts, what is the overall height gain for the lift?

[@johnmorris77]

3.5 inch in front, 2 inch in back. 6 inch kits are 6 in front 4 in rear so I suppose it's a "3.5" kit.

[@jeffrittenour8202]

These trucks sit 3" higher in the back from factory. So it's like a leveling kit plus another 2" in the back.

[@TheIamdevin]

@@jeffrittenour8202 each one of these trucks are different. I had a 2.5 front 1.5 rear procomp kit on my first 5th gen and it sat perfectly level. My new truck is easily 2" of rake

[@carlos.velazquez]

What’s the ride quality on this, I bought this already but didn’t realize how many people complained about the ride quality now I’m hesitant on installing it.

[@CustomOffsetsTV]

It’s varies on what people consider to be good ride quality, we say it has good ride quality! 🙏🏻

[@hasnainilyas224]

Just eanted to hear from u again on hoe it rides with this im looking into lidting my 2020 ram also

[@iivanTV]

How much stiffer do the preload spacers make the ride ?

[@CustomOffsetsTV]

It depends but a little stiffer!

[@bustayu]

Shawn needs to come back

[@CustomOffsetsTV]

Soon!! Let’s get a request going to get him in!

[@bustayu]

@@CustomOffsetsTV I'm in !!

[@redsamurai6586]

Before and after photo?

[@eleazararellano8269]

Hello 3" full rancho level with coil or 3.5 sst ready lift which one is a better ride quality? Help here thanks.

[@AllNoisez]

What would happen if I install these in my 2019 1500 4x2 v6?

[@frankfordgarage5711]

If they corrected the upper ball joint angle, what about the lower ball joint angle and how bad are the CV angles ???

[@CustomOffsetsTV]

They typically get corrected all together

[@jaywedsted4159]

Could you elaborate on tire/wheel fitment? Ready lift recommends up to a 35” tire on a 20x9 wheel with 0 offset...That is a stock wheel size? Most people will want to run a more negative offset?

[@TheIamdevin]

Bit late but dont mind readylifts conservative tire size recommendation,i had 10 wides and 35's on a 2.5" level with no rub after some minor tweaking with the plastic fender liners. No cutting,just heated them up and pushed them back and zip tied the back part back

[@crrz-ws1qn]

Did you have Any lift kit for air suspension ?

[@CustomOffsetsTV]

Unfortunately we do not yet carry any lifts for the Ram air suspensions. Check back soon!

[@matthewbutler8523]

I’m on a tight budget what would a good wheel and tire combo be for around 1500 to 1700

[@CustomOffsetsTV]

Depends on the make and model! Check out what we have available for your truck! -> www.customwheeloffset.com/wheels-tires

[@bms-wb6yi]

@@CustomOffsetsTV how stiff does this make the ride? Is it unbearable?

[@6.7psd31]

Can u put a 35x12.5 on that stock 20 inch wheel without it rubbing control arm or does it need a wheel spacer?

[@teke237]

Think you can. The website says so

[@jed2812]

Is this compatible also for a 2WD 2019 Ram 1500?????

[@CustomOffsetsTV]

Please email us at [e-mail] so we can ensure fitment!!

[@JuanRamirez-oz7hh]

Did you end up getting it? I’m looking into it for my 2020 2wd also

[@JoseHdz9]

It is. I just installed it on my 19 2wd with some 35/12.5/20 nitto ridge grappler.

[@jed2812]

@@JoseHdz9 u should upload a video. Tag me when I do. I wanna see it I haven’t pulled the trigger yet. Thanks

[@bms-wb6yi]

How stiff is the ride going to be.....since the spring is compressed with the spacer the spring rate has to be so much higher....

[@Puraley-0720]

Is this good for a 2018 eco diesel?

[@CustomOffsetsTV]

No, check what works for you here! www.customwheeloffset.com/suspension

[@dylanlinke8619]

Will this level the truck or maintain factory rake?

[@IamChucky_]

I believe it will still have a 1 inch rake with the readylift 3.5 sst. A 2.5inch motofab leveling kit will level the truck perfectly and add a readylift uca for piece of mind.

[@raphaeltovar4559]

Will this help fit a 35/12.5 on a 20x10 -44?

[@CustomOffsetsTV]

Yes it would help

[@chiefkeefatl8236]

2wd drive???

[@jed2812]

Chief Keef ATL!! Is this for a 2WD too?????

[@truck212121]

2018-19 Nissan frontier

[@ozzy1355]

does it still sit higher in the rear end?

[@CustomOffsetsTV]

No it shouldn’t

[@919hey]

Dosent this max out your stock shocks and give it a shitty ride?

[@Jimitrammell]

the spacer in the front coilover will increase the springrate slightly but the top spacer will not change it. and the rear spacer would compress that spring more so i would think the ride would be stiffer. It wouldnt max out the shock unless you feel the need to launch it off curb or something :-P

[@Jimitrammell]

all in all for being a non invasive " lift kit" customers love them

[@cjrench1845]

Alright I’m back I wanted to scare Ya know Halloween vibes

[@Killacam440]

Eww. Hire banker for these videos. Hell I'd like to even see fuller do them

[@CustomOffsetsTV]

Bankers been working on the Trucks!!! Maybe sometime soon he will be back 😅🙏

[@powerstroked6956]

First to comment

[@eloychavesjr7022]

Would stock trx wheels and tires fit with this?