Lightsaber Hilt Build from Plumbing Supplies - DIY

[@adamsifford6228]

I've used old attachments from vaccumes too.

[@KirkandRA]

I was installing a faucet yesterday and I looked in amazement of what I had. 😳

[@rangerluxray4343]

I can't believe you only have 63 subscribers

[@SupBro-ww9go]

Pretty good

[@NormGagnon]

Great fabrication my friend!

[@leeseth.07]

Cool

[@izzyb5729]

How would you attach a way to carry it around on a belt? I know you can use a cover tech wheel or a d ring but I’m not sure how you would go about installing either of those onto this hilt

[@FourPeaksCreations]

A flashlight belt clip would probably be best to keep the hilt from bouncing against your leg. You could also replace one of the washers at 5:40 with a D-ring picture hanger.

[@izzyb5729]

Four Peaks Creations Thank you!! I’ll see what I can do!

[@KarateBuster]

@Four Peaks Creations can you do one on how to make a fall saber hilt. a fall saber is a double bladed light saber

[@FourPeaksCreations]

Sounds interesting, I'll look into it.

[@atalantafugiens0426]

Is this hollow enough to house electronics?

[@FourPeaksCreations]

I'm not sure. Some of the smaller boards look like they might fit.

[@ReaIiPlayBedwars]

Where can I find the aluminum tubing?

[@FourPeaksCreations]

A hardware store with a plumbing section would likely have the tubing. I found mine at Lowe's on the shelf right next to where I found the drain.

[@ReaIiPlayBedwars]

Four Peaks Creations thanks!!

[@fish3r587]

Lowe’s

[@fish3r587]

Oh wait, you already said that🤣

[@jordanlewis3927]

When you measured the length at 3:14 , how long was it? And how long was the entire thing after you were done?

[@FourPeaksCreations]

I cut about 5" off of the 12" tube, so the total length of the finished hilt is a little over 11".

[@angelinarojas165]

hey do you think that you can attach a blade to this if you can pls tell me

[@FourPeaksCreations]

You can, similar to the way Punished Props does it here: kzbin.info/www/bejne/d5-WeI2Gh6lpmtE

[@jeffannan2682]

What kind of rotary tool were you using?

[@FourPeaksCreations]

This one www.harborfreight.com/flexible-shaft-grinder-and-carver-40432.html?_br_psugg_q=rotary+tool it's inexpensive and works fairly well

[@zoom7976]

Slow down

[@louisvarre2197]

Some narration would be good....it really detracts from all that work you did. By the end of the video I was no longer interested in the final product.

[@_Henners_]

Cool