Lightweight DT for Sweet P30

[@sarmedalneemy2066]

👌💚💚💚👍

[@rogerjoesbury9410]

Good morning I hope you are keeping safe in these strange days.when you selected your damper was it the one with low talk)

[@tomtflyer9127]

Hi, It was the FRT-G2 600. Hope this helps!

[@rogerjoesbury9410]

@@tomtflyer9127 what tension does the rubber band / spring pull?

[@tomtflyer9127]

@@rogerjoesbury9410 This is the bit you have to cut and try for yourself! What I can tell you is that my rubber spring is a 2.75" loop of .025" wide Tan Sport rubber. It needs less than you think, but the band has to be stretched hard. You have to match it with the tail band. If the tail band is too strong, the DT can't pull the tail flat firmly enough. Too weak and the pop up isn't good enough. I just played around with differnt combination until I found one which worked. One tip.. I used a micro safety pin as the joiner on the rear end of the DT line, so I could do quick changes of different loops . Hope this helps.

[@johnmoss4140]

sorry to be ignoarant but, what is a DT?

[@tomtflyer9127]

Hi John DT stands for dethemaliser. It is a deviice to stop models flying away when caught in a warm air updraught. I had one glider which was found 25 milesaway a long time ago!