LiPo balance charging with Imax B6AC charger

[@boom1708]

Charge current is NOT always the same as capacity... Setting charge current should always be reference from the battery data sheet. Following this advice could cause a battery to explode.

[@Callsign_Ewok]

Awesome thank you very much. Helped me get my 7.4v Li ion titan airsoft batteries setup up on my b6ac version 2 :)

[@TheWishyFishy]

Thnxxx A truth hero.

[@thatrcguy9871]

Thx man just liked and subscribed:)

[@albertmeyn9652]

Shouldn't a single LiPo cell be loaded with 4.2Volts? With 3 cells you are at 12.6Volts. 3.85 to 3.95 Volt is the storage capacity of a LiPo (3S = 11.55V). So you are loading with storage capacity only... What does the specification say?

[@zombiesquadairsoft1492]

You are correct. For a single cell to be fully charged it should be 4.2v but in this video I don't mention the cell voltages and I am only demonstrating how to start the balance charge process. It dose not show the completed charging process.

[@bmzaron713]

Man, what an awesome video... If I have three 18650 cells in parallel, say about 12 amp hour capacity, you wouldn't recommend charging at 12 amps (or whatever the highest charge rate is) would you? Isn't that bad to charge at a higher amperage?

[@zombiesquadairsoft1492]

Sorry mate couldn't comment on using 18650 batteries as I have no experience with them.

[@ilililiilililili]

thx

[@Greg-wi7qw]

Dude. Ive just bought the same charger. This one is FAKE. Counterfeit product. There is a good demonstration vid on here on how to tell.