Lister SR2 marine rebuild (part 1)

[@van63lighthaulage98]

Sir...I am mesmerized and enthralled by your talent and obvious passion for these engines...I know nothing about such things but my hunger for more knowledge and insight into your skill is growing daily....Top Man...Thanks for being you.

[@sam-di4oz]

You are dam professional mate

[@dougabrahamsen2952]

My word! So much information and knowledge presented so well! You really need to do the same with your more recent videos. 😊

[@VintageDieselCenter]

Thank you Doug.

[@dougabrahamsen2952]

@@VintageDieselCenter your very welcome! Credit only given where credit is deserved 😊😊😊

[@DEmma1972]

Came here from the boat that James built. Great knowledge on the engine.

[@OldFloatingSeaman]

Same here

[@chrisjesson9042]

Same here, the boat that James built mentioned your channel.

[@VintageDieselCenter]

Glad your all here. Hope you're enjoying the content and information on these lovely old beasts. Cheers LDW

[@delwalter5773]

Sir Petter PH2W - can I adjust the bump clearance between the cylinder head and the cylinder barrel or do I have to do it between the crank casing and the bottom of the cylinder barrel? Regards Del

[@YTumburesi]

Good chanel. Hallo from Indonesia.

[@NormanGnome11]

What happened to part 2 ??

[@grahamlangston2101]

I've a lister sr 1 been struggling to find the standard size for the crank shaft got a spare one but no idear if it's been ground do you know the std size please

[@VintageDieselCenter]

Hello Graham. I will check my Lister Grinding books tomorrow and will get you the required sizes. Cheers LDW

[@grahamlangston2101]

@@VintageDieselCenter hi the spare crank I would like to use measure 2.246 thow mains and 2.241 big end how far is this off standard and is it usable my engine biulders say its a pain to grind as it would take to long to reset there machine and cost 80 pounds

[@sam-di4oz]

Hi mate May I ask how much is it to fixed?

[@janardanmeher9763]

Hey sir.. Please share this engine Rebuilt part 2... 🙏🏻🙏🏻

[@VintageDieselCenter]

Il see what I can do matey. You can see the finished engine here: kzbin.info/www/bejne/oZe2d5SaoLp4btU Ben

[@imradali6382]

Goog