LOCKMASTER Swing Gate Opener Kit

Swing gate opener kit sold by TopmaQ
www.topmaq.co.nz

[@PlasticAssasin8]

geez, who welded that gate hinge on? Hope they didnt pay for that work

[@orgasmictomato]

Anyone have a problem with the FACT that they list the control boxes to be installed "in a well ventilated place protected from rain and sunlight " - what??? considering the boxes are supposed to be watertight and would assume UV protected PVC.... I am about to install a set of these and there is NO manufacturer listed for any sort of back-up at all. Check Google yourself. The resellers are not able to give any answers or support, really. So be aware of these faults before you think your getting a good deal.... be able to service all aspects by yourself... Oh and even with a 2 unit set they still only supply a 1.5m lead on the motors, requiring a junction box joint to reach back to the control box panel. This is just bad design..... as they are promoted for gates of wide application but not wired for it. I am a electrician, but DIYers beware, there are little recommendations of cable sizes you will need for the installation (use at least 14AWG, 1.84mm2 ) and none of the screws for mounting are steel post capable. Oh and getting any decent range of accessories for the job, - forget it. I still have not found a supply of "exit wand" LM157 in Australia. Not to mention that a electric lock will cost you nearly half the cost of the opener unit. Jim 😎

[@gianfrancobriones]

The "Only 1.5 meteres is supplied" is funny. Arghhhh. Because of this, I wrongly bought 2×0.75mm² 18AWG *(WHICH SHOULD BE 1.0mm² 17AWG for the motor)* and 3×0.3mm² for the actuator's limit switches. Had to also separately buy two waterproof junction boxes.. so much hassle!

[@tenmillionvolts]

I'm just fitting my ones now. I went to set the inner limit switch and found out you are not supposed to. This video says you can set it but then says don't touch. What??? Have you set the inner one before or do you have to leave it? For my setup, I need to change it really.

[@jonatanpagdanganan]

Sir can you teach me the wiring connection of DC24V heavy duty swing motor

[@victorarce3643]

Can you teach me how to fix my motors when I close them they open by there self's after 1 min and I have it in confirmation push

[@rickbates9232]

I came for the piano concerto ... it apparently has something to do with gates ...