Here are the items I purchased outside of normal tools I already had. Lights amzn.to/4eXoIe6 18 gauge/3 strand wire (BLACK) amzn.to/47ZYQMt 18 gauge/3 strand wire (WHITE) amzn.to/3U3ZYcc Crimp kit amzn.to/4h1swgg Heat gun (Ryobi) amzn.to/3ZZLJsY Heat shrink amzn.to/3ZTqCIH *Reminder on screws, each bracket probably takes 2 screws, so do your math on quantity needed!* Mounting bracket screws #10 3/4 (BLACK) amzn.to/3NhLv8G Mounting bracket screws #10 3/4 (WHITE) amzn.to/4eZJ5HH Coax staples amzn.to/4gYZ1f1 Tool pouch (you’ll be glad you did) amzn.to/3ZZEilA If you click on links I provide, I may receive compensation.
@Dads_DIY_TXКүн бұрын
Make sure the wire that has the writing on is reading (correctly) from left to right.. ie if you put it in good light you’ll see something like “24 AWG” and/or “300 V”. The “2” goes on the power supply side of your run and the “V” goes toward the end of the run
@Dads_DIY_TX2 күн бұрын
Here are the items I purchased outside of normal tools I already had. Lights amzn.to/4eXoIe6 18 gauge/3 strand wire (BLACK) amzn.to/47ZYQMt 18 gauge/3 strand wire (WHITE) amzn.to/3U3ZYcc Crimp kit amzn.to/4h1swgg Heat gun (Ryobi) amzn.to/3ZZLJsY Heat shrink amzn.to/3ZTqCIH *Reminder on screws, each bracket probably takes 2 screws, so do your math on quantity needed!* Mounting bracket screws #10 3/4 (BLACK) amzn.to/3NhLv8G Mounting bracket screws #10 3/4 (WHITE) amzn.to/4eZJ5HH Coax staples amzn.to/4gYZ1f1 Tool pouch (you’ll be glad you did) amzn.to/3ZZEilA If you click on links I provide, I may receive compensation.
@Dads_DIY_TX4 күн бұрын
Pros may be able to go further before you need a booster. Likely because it’s pushing more power to begin with. Can’t verify myself.
@Dads_DIY_TX5 күн бұрын
Careful with the heat gun doing heat shrink over the light, especially if you removed it from the puck! Don’t want to melt the circuit board!
@Dads_DIY_TX5 күн бұрын
If you need a light, cut the last one off a strand, then cap/heat shrink that spot. Yes, you can cut any of them, just voids the warranty on non-pros. I cut 3 off to make this video, the lights remaining still work.