Lowrider 3 CNC - first cut test!

First true cut test of my Lowrider 3 on a ping pong table. It worked better than I expected!

[@clayscustom]

Nice looking build! I am in the process myself and yours is the first one I have seen with a Bauer Trim Router mounted. Could you direct me to where you found a mount to fit the Bauer router?

[@jamieadams4310]

It's the exact same size as the recommended Makita router so you can use the same mount.

[@clayscustom]

@@jamieadams4310 Thank you for the info!

[@IggyJackson]

How'd you end up fixing the z axis limit issue?

[@jamieadams4310]

I posted it in the previous video, but I'll make a video showing how to fix it.

[@adamathypernerd7728]

From the other video: "Found the solution. Apparently some of the SKR Pro 1.2 boards have experienced issues with the on-board pullup resistor for the limit switches. When the endstop is triggered, the led comes on, but that causes the voltage to drop so the firmware is not seeing the correct voltage. I've added an external resistor to that endstop and all is well."

[@Craft.1]

What size work area

[@RadekSzabla]

What kind of motors are you using - its running mutch faster than mine low rider 2 on - regular nema 17

[@jamieadams4310]

Just regular Nema 17. I ordered the ones that V1 Engineering recommended.

[@adamklosterman8960]

What controller and software you using?

[@jamieadams4310]

It's the BTT SKR Pro V1.2

[@Craft.1]

How i can get this cnc

[@jamieadams4310]

Look up the lowrider 3 cnc. You make it.

[@bigsexyonice]

I’m a total noob but how is your spoilboard and project mounted so it doesn’t move when it’s operating

[@jamieadams4310]

I just screwed it into the table. I'm working on a redesign to have a permanent spoilboard.