Рет қаралды 1,003
LowRider CNC - Jackpot Board - End-Stop Connector Combiner (Make-A-Block Clamp for 2.54 Pin Housing Connectors)
For more on use of the Jackpot controller with a LowRider v3 CNC, watch these other short videos:
• LowRider v3 CNC - Tram...
• LowRider v3 CNC with J...
• LowRider v3 CNC with J...
• LowRider v3 CNC - Squa...
Printables download link: www.printables...
Print info:
Print as oriented.
Prints without supports
I used my standard default of 0.3 layer height on a 0.6 mm nozzle. However, a 0.2 or 0.1 layer height (higher quality print) would be fine for a part this small.
Assembly info:
On the "Back" part, there is a 1-layer thick sacrifice layer across the holes where they transition from nut capture slots to screw holes. You can remove that layer from the holes by either a hot soldering iron, or a drill bit, or an Xacto knife.
To insert the two M3 nuts in the nut capture slots, you can thread a nut onto an M3 x 20mm (or M3 x 16mm) screw, and then hold the screw with needle nose pliers, and either bang on the screw with a hammer to seat the nut, or heat the nut up with a heat gun, and let it melt its way into place, by pressing it with pliers gripping the spare screw. A nut capture slot has to be tight or it won't do its job.
Once the parts are ready to clamp together around the 2.54 mm pin housings, attach them to each other using two M3 x 8mm screws.
The case shown in the video is this one:
www.printables...
Change log: November 19, 2023 - Initial v1.0 uploaded.
My PayPal tip jar: paypal.me/desi...
Various LowRider 3 CNC remixes: www.printables...
View all my models and remixes on Printables: www.printables...
*Product links may be affiliate links, which add nothing to your price, but may benefit me by a small percentage.