M*CARBO Kimber Micro 9/Micro 380 Trigger Spring Kit - Updated Install Video 2023

Get The Spring Kit Here - www.mcarbo.com/kimber-micro-9...
Please refer to the timecodes below for specific chapters.
TIMECODES:
Intro - 00:00
Tools Needed - 00:07
Stock Trigger Pull - 00:23
Disassembly - 00:59
Bending Sear Spring Legs - 05:21
Reassembly - 06:29
Modified Trigger Pull - 10:37
#kimbermicro9 #kimbermicro380 #kimbertriggerjob

[@kentgearner]

Do not be fooled, friends. This man is a sorcerer! He makes it look easy. The sear/extractor section will TRY YOUR SOUL! Good product, though.

[@stickermigtigger]

I was questioning installing this kit while trying to get the sear installed. Need five hands. Must have picked one of those parts off the floor a couple dozen times. I wondered if I could do it backwards so I pinned the sear and the extractor first, then slide the sear spring in under them, held down the sear spring with a finger and slid in the main spring housing in and pinned it. Done in 30 seconds. Spent an unsuccessful hour the video way. Now for some shootin! 😁

[@cliffbailey6474]

Great kit! Also purchased recoil spring. Just returned from the range and the difference is night and day. My Micro 9 trigger is so light and smooth and never a misfire. Video made it super easy.

[@peterf8775]

Just like that.....sort of....thanks great video

[@codyjenn8785]

Thank you mcarbo for the awesome video.

[@williamhalstead9981]

I have had my sear spring on my kimber micro 9 in and out probably 20 times. Installed mcarbo kit. Not that much improvement. Not once have I had to remove sear and extractor. Sear spring falls right into place. No problem.

[@timothybellsr.293]

Hey can you do a video on changing the safety spring and plunger for a Kimber 380 acp micro carry?

[@adrianjr3629]

I lost one of the retention pins that go into the mainspring assembly. Any help on where I can find it?

[@nelsonr1467]

Are you guys going to make more metal mag catches for the Keltec P32

[@SinOjOs-Transport]

Would be better if he would provide a better view without his hand or finger in the gd way. SLOW DOWN, WE KNOW YOU KNOW HOW TO DO IT, WE DO NOT! Wish these companies would hire a professional to make the video. Having the kiddies that does it all day every day, is not the best person to make the video. Still cannot figure out which way the dam sear goes in. One shot shows it one way on the pliers, other shot, looks like it is the opposite way., Then he blocks the view with his hands. Then after it is in, his dam fingers are in the way, no f'n way to see, wtf. He really needs to watch his own video, with the perspective of someone who has never done it before. Probably the lowest paid & youngest employee. Must be an engineer, who famously have no capability to look at anything from someone else's point of view.