M119 Installing Throttle Linkage and Vacuum Hoses

[@nawarhishan]

Thank you for the amazing video, it came in time for me because I'm going to replace all my vacuum hoses and crankcase breathing tubes!!!

[@FriendlyMBTech]

You're welcome. I'm glad I could help.

[@julianhickman5874]

you are a legend

[@FriendlyMBTech]

Thank you!

[@SayMyNaamee]

Thanks

[@iamhapidays8766]

Outstanding video. The only one after hours of searching. Do you have video for attachment of the white small vacuum tubes.

[@FriendlyMBTech]

I go through connecting the vacuum hoses and lines in the engine installation video. Also, I did a correction video after I connected them incorrectly. In the video of removing the engine I point out where the vacuum lines are connected as well.

[@Hbsir3453i]

First thank you for your complete and thorough post....Do you have the part number for the connectors?

[@FriendlyMBTech]

You're welcome. Which connectors do you need part numbers for?

[@Hbsir3453i]

@@FriendlyMBTech to connect the hoses. The Y

[@FriendlyMBTech]

@@Hbsir3453i sorry, I never got the part numbers when I bought them. The straight connectors are A 117 990 15 78 and A 102 094 02 12. The small rubber Y is A 119 094 03 12 and the plastic connector with the clip is A 119 094 02 12.

[@syedshahid492]

My name is SYED. I have a1995 MB SL 320 on which I have replaced the wiring harness, EGR valve, Vacuum hose and tubes. I have small issue for which I need your help. During the replacement of vacuum lines, my connection of the black tubes from the solenoid/vapor purge valve to the Throttle body got disconnected. Can you please just send me a rough idea where to connect it on the Throttle body (upper/lower/left/right side when viewed from the driver seat). Because of the disconnection , I am getting the OBD 11 code P-0441 (Evaporative Emission System Incorrect Purge Flow). If you can add a hand sketch, that would be great. Regards, Syed

[@FriendlyMBTech]

@@syedshahid492 I'm sorry for the late reply. I don't have a diagram like that. I'll have to research it to try and get you some more accurate information. Please email me.

[@w210black]

I need help with the hard vaccime lines

[@FriendlyMBTech]

Ok. How can I help you?

[@reyhandzeko2174]

Please tell me you have a video for the small vacuum hoses

[@FriendlyMBTech]

I am so sorry if I never responded to this. I thought I had. The small vacuum hose routing is part of the removal of engine videos. I go over each line amd where it goes to and from. There is also a Short where I point out how I mistakenly routed them wrong.

[@FOR_THE_BOYZ]

Ээ