Machining an ER32 Collet Chuck

[@AmateurRedneckWorkshop]

Good job there Dave. That is a really nice tool. Thanks for the video keep on keeping on.

[@TheMiniMachineShop]

You bet

[@homemadetools]

Nice job yet again. We shared this video on our homemade tools forum this week 😎

[@TheMiniMachineShop]

Awesome! Thank you!

[@HM-Projects]

Nicely done, ER chucks are relatively straightforward to make if one's careful. In most case it's cheaper to get a whole bunch of ER nuts and make the collet chucks yourself.

[@TheKnacklersWorkshop]

Hello Dave, Nicely done there... I know you've had a few challenges but it must be a nice feeling that you're overcoming them... Take care. Paul,,

[@TheMiniMachineShop]

Thanks 👍

[@joselopezruiz3972]

Siempre lo he dicho muy instructivo

[@Stefan_Boerjesson]

Cheers Dave. Videos from You are always interesting and welcome. Hope to make some pictures of my 5" rotating table and the aluminum plate nailed to it and Email You. The same approach ought to work on Your rotating table.

[@TheMiniMachineShop]

Fantastic!

[@Stefan_Boerjesson]

@@TheMiniMachineShop Pictures are on their way.

[@barrysotero137]

Some tables (like my old German one that my Opa gave ) take 4 revolutions, some take 6.. depends on the #of holes vs. ratio… you were probably expecting that particular set up to work in one Revolution(360) vs multiple rotations… Regardless, You will get it….🤙

[@jimbarchuk]

They call him..... The Dividifier.