Machining Toyota IFS Hubs for Big Brake Mod on Dirt Garage!

[@DirtGarage]

How did I miss this upload?!? Thanks again man!

[@analog56x]

No problem :) does Cory still want a set machined for budget truck?

[@DirtGarage]

@@analog56x You know it!

[@analog56x]

@@DirtGarage awesome :) what timeframe is he looking at?

[@jsvallee567]

just saw the video on dirt garage channel and was wtf i miss that upload !! great job bud !!

[@indiankite7358]

Totally awesome!

[@palaciosivan100]

Will 01 4runner 4wd rotors work? I have some laying around?

[@SOLDADITO76]

Was curious, which rotors work best. Rotors from a 89-95 V6 pickup, or a 96-01 V6 Tacoma?

[@MudRFunR]

Nice!

[@isaacmoreno8352]

Can I use the 1993 4runner 2gn brake discs on the hilux front solid axle? Greetings Panama

[@analog56x]

not really, no. you'll run into issues with hub clearance. unless you put the rotor on the rear of the hub, but that defeats the purpose, and i also dont know where you'd end up having to place the caliper.

[@richardtapia8030]

What Rotors are those Tacoma or pickup ?

[@analog56x]

1998 tacoma rotors. Its all there in my build thread on marlin crawler :)

[@analog56x]

Link is in the description ;)

[@SubePelayo928]

How long did you spend turning them down?

[@analog56x]

I think i had it down to 10-15 minutes each. The hardest part is the setup. Total time taken on setting up the lathe, machining, and setting the lathe back to how it was was about 2 hours. If i had a lathe with a bigger swing, it would have taken probably 45 minutes. I had to do some kinda janky stuff to be able to turn them haha

[@SubePelayo928]

@@analog56x I need mine done so this helps with cost per hour estimate

[@analog56x]

@@SubePelayo928 awesome, glad i could help. Most machine shops charge 1hr minimum, so depending on rates, you could spent up to 150$ id imagine.

[@trevordarnell673]

Been awhile bud

[@analog56x]

Since you tuned in, or? How's it going?

[@trevordarnell673]

analog OffRoad yes and for some good ole Toyota content

[@analog56x]

@@trevordarnell673 yea man! Welcome back :) theres going to be much more toyota content in the near future :) the mazda build is going to be about 80% toyota haha

[@trevordarnell673]

analog OffRoad sweet. I’ll stay tuned man I love your videos

[@analog56x]

@@trevordarnell673 Thanks bud! take care!

[@really_jack]

5... five what! .5”... 5mm? asking for a friend how much you took off

[@analog56x]

Its different for every hub... just machine the hub down so its like .050" clearance, and you'll be fine.