MAJOR UPGRADES(Pt.2) BILLET HEAD😈

[@kgol4686]

For this kids engine he's Smart as hell keep wrenching brother you are a lot better then these other wanna be engine builder's on KZbin keep up the good work man

[@privatedata665]

I have been a Tech for 42 years . I have some advice . Keep doing what you do . I'm jealous 😃

[@jeffreyodachowski6247]

Badass man

[@EverythingEngines]

@@jeffreyodachowski6247 thanks bro🤝

[@Tarzan_Got_U_626]

How many cc is that engine? What's your bore size?

[@trymeofficial276]

🔥

[@Deucealive75]

How did you choose head gasket size? Were you going for a specific static compression ratio?

[@EverythingEngines]

Tbh I went with a thicker one just so I lessened the risk of tearing one but now thinking about it I might put a thinner one back on

[@Deucealive75]

@@EverythingEngines Make sure you have around .030" in between the piston and head. For example, if the piston is right at the deck at TDC then use a .030" copper or .036" head gasket. If it's .020" in the hole then use a .010" gasket. If it's .003-.005" in the hole then use a .027" head gasket. The thicker gasket is safe but with a small compression loss. No big deal at all.

[@EverythingEngines]

@@Deucealive75 ok thanks my only hesitation with a thinner gasket is cause I was worried about piston to valve clearance

[@kgol4686]

For this kids age he's smart as hell is what meat to say in my last message and a hell of alit better then most of u other wanna be engine builder's keep wrenching brother

[@EverythingEngines]

Thank you man 🙏🏼🔥

[@m4sch3r46]

Which engine is this?

[@EverythingEngines]

My predator 212 the same engine I did the stage 2 kit on few months back

[@jaystrappa]

For future reference you don’t need to tighten down the head bolts like you did man. I hand tighten them and never had an issue brother.

[@EverythingEngines]

I had one of them come loose even after I tightened them recently and blew a head gasket so thanks but I’m going to torque mine

[@EverythingEngines]

Unless your talking about the head studs in that case yeah I didn’t know at the time thanks for the tip

[@jaystrappa]

@@EverythingEngines Yes studs lol not bolts