Рет қаралды 48,017
Maccy and Ms. Fox teach you how to make a 3D printed mini Macintosh that actually works!
Let us know if you made one too!
Check out the original Instructables article by CGenco at:
www.instructab...
- Mini vMac ARM Executables by CGenco:
www.dropbox.co...
- Mini vMac Gryphel Project (Roll your own executable!):
www.gryphel.co...
- 3d Model of the SE/30: www.thingivers...
-Sketchup file of the mini SE/30: www.thingivers...
- Disk Image with Macintosh System 7.5.5 ready for Mini vMac: archive.org/de... ( you will need to use 7zip or Keka to extract)
- Macintosh II ROM: Search for: 9779D2C4 - Macintosh II ROM file
hampa.ch/pub/so...
-----
Components I used:
Raspberry Pi Zero W: www.adafruit.c...
40-pin GPIO Extension Cable: www.adafruit.c...
2.8 inch Touchscreen for the Rasberry Pi: www.amazon.com...