Makerbase SERVOxxD Closed loop Stepper Motor Example1 PC Control Software example

[@didjzej]

What is the max range when returning to zero after power on? Is it just 0-360° range when finding zero, could it be 0-36000°? since I'm planing to use gearbox on the motor. Thanks

[@alexbaronov4736]

It seems that servo42D does not support 0.9 degree steppers, contrary to what the Aliexpress Makerbase Official Store claimed. Is there a firmware upgrade that can fix this?

[@alexbaronov4736]

I just received two of these boards. Unfortunately could not test yet since calibration throws a Reverse Lookup Error. Rotor spins, and I tried adjusting magnet distance to the PCB, but calibration fails. What could be wrong?

[@osmargarnica]

Is your motor a 1.8º? I was having the same error when testing my 3.6º motors. They claim the driver supports only 0.9 and 1.8.

[@alexbaronov4736]

@osmargarnica my motors are 0.9 degree, whereas apparently these particular boards do not support that. I don't know about 3.6, but my 1.8 worked.

[@jojos681]

Is there a version that works also with the CAN interface? Not like the low level Cangaroo?

[@kmcrafting4837]

Ditto... did I buy the wrong version?

[@aparateauditive]

Can I control the 485 model trough modbus? If so, how? Would be very nice if I could control it trough a HMI on modbus protocol.

[@aparateauditive]

Very nice product! Where can we find to download the MKS ServoD Control v1.0.3 software please?

[@makerbaseteam4217]

hello ,the code is uploaded to github. github.com/makerbase-motor/MKS-SERVO57D/tree/master/MKS_ServoD_Control

[@friedrichheckel1302]

Bitte senden Sie mir ein Deutsche Übersetzung das Programm ist super MfG Friedrich Heckel