Making a rivet nuts tool

[@eltonm.t.873]

Nice tool, the best design I've seen!!! However, I would leave the bolt head so that I could use a battery powered impact screwdriver instead of old fashioned corded drill. Also, I would devise a way to be able to change the screw tip to drive different rivet nut sizes, the screw tip could be Allen screws of different sizes/gage 'cause they are much harder and less prone to thread damage.

[@KwandoTechnic]

Thanks for your advise!

[@davidschwartz5127]

You would be surprised, I always had that same assumption about Allen bolts, until I need to drill on out they are the same unless you by the as grade 5 or grade 8.

[@MrJamesoro]

como se llama ese tipo de chazo? excelente video

[@KwandoTechnic]

Thank you so much!

[@MarcosAurelio-dj6zy]

👏👏👏

[@giovannisampalmieri2138]

scusa se contesto il tuo operato, ma come può il dispositivo e di conseguenza il trapano allontanarsi dallo scatolato dove hai inserito il rivetto se il mandrino del trapano gira in senso orario. una volta inserito il rivetto, il mandrino del trapano dovrebbe girare in senso antiorario. questo dovrebbe avvenire nei minuti 9:30 e 9.31. correggimi se sbaglio.

[@KwandoTechnic]

When removed, it will rotate in the opposite direction

[@gatpaw]

Nice build. May consider using cutting oil when drilling to make the process easier and protect the drill bits.

[@KwandoTechnic]

Many thanks for your advises!

[@hyperhektor7733]

what gas / gasmixture do you use for the welding?

[@KwandoTechnic]

Argon gas.

[@bruynemarina6074]

Well done! Great build and very useful with this tool.

[@KwandoTechnic]

Thank for your opinion!

[@nagarandempire3261]

Does anyone try this tool

[@davidjames1063]

Only problem Material wise, Grade 8, or better nuts and bolts should be used.

[@POULPY47]

Thanks à lot ! You're working very well! What's type of TIG you're using?

[@KwandoTechnic]

This is my welder. You can order on it: bit.ly/30T55h0

[@POULPY47]

@@KwandoTechnic thanks a lot!

[@KwandoTechnic]

You are welcome!

[@POULPY47]

@@KwandoTechnic were do you from , you seem very sympathetic ! Hello from France !

[@KwandoTechnic]

Where I am no important. I respect everybody. I want to support everybody as I can.

[@cameronhadley6126]

are you kidding me?

[@KwandoTechnic]

No, thanks!

[@BillSmith-kl7sb]

lol grossly over engineered. I just use a High grade bolt, washer and nut drive socket on a drill. Hit the bolt with wd40 and it pulls tight in a few seconds. Why all the pipe and crap in between lol.

[@АлександрВаганов-ж3ы]

зж